How fast can you reach Newark?

Same day in most cases, about a 35 to 40 minute drive from San Ramon down I-680. A dead machine costs a cafe sales, so we hold after-hours slots for shops that need to open running.

Do you stock parts or source them?

Common wear parts are on the van, brew-unit seals, gaskets, valves. Boards, grinder burrs, and pumps we order per machine since they vary by line. We confirm stocked versus sourced first.

What does a repair cost?

Diagnostic is $75 and we waive it when you book the repair. You get a written quote before any work, so the number is set before we start.

JURA · NEWARK

Service · All Jura Models

Jura Commercial Coffee Machine Repair · Newark, CA

Jura commercial coffee machine repair for Newark offices and cafes.

$75 diagnostic (waived with repair)
Same-day best effort
CSLB #1136642

Call (925) 999-4095

Jura in Newark

Jura commercial service.

Newark commercial coffee centers on the Pacific Research Center and the office and retail along Cedar Boulevard and around NewPark Mall, 94560. Offices in the business parks run Jura super-automatics in their break rooms, and the cafes near the mall keep a few going through the day.

San Ramon to Newark is about a 35 to 40 minute drive down I-680, so we can usually get a tech out same day. We service Jura as an independent shop, and CSLB #1136642 covers the electrical and water-line work on these boiler and electronic machines.

Common repairs we do

What we close on the truck.

Brew unit wear and gaskets. Break-room Jura machines in the business parks cycle the brew unit hard, so seals go first. We rebuild or replace the unit on X-line and GIGA Professional machines and reset the brew action.
Descaling and thermoblock heating. Plumbed machines scale the thermoblock with local water. We descale, check heat-up, and fit filtration so a break-room or cafe machine stays consistent shot to shot.
Pump and flow meter. Weak pressure and stalled brews point to the pump or flow meter. We test both, replace what is failing, and confirm steady flow through the group.
Ceramic grinder and ceramic valves. Dull burrs thin the cup and scaled ceramic valves choke flow. We clear and inspect the grinder, reset dose, and clean the valve and drainage path.

Models we service

Jura product lines.

GIGA X3 and X8 Professional
X8 and X10
WE8

Pricing and warranty

What it costs. What we stand behind.

$75

Diagnostic visit. Waived when you book the repair with us.
1 yr

Parts and labor warranty on completed repairs. In writing before we start.
CSLB

#1136642. Bonded and insured. We file warranty paperwork when applicable.

Nearby cities

Jura service in neighboring cities.

FAQ

Jura in Newark questions, answered.

How fast can you reach Newark?

Same day in most cases, about a 35 to 40 minute drive from San Ramon down I-680. A dead machine costs a cafe sales, so we hold after-hours slots for shops that need to open running.
Do you stock parts or source them?

Common wear parts are on the van, brew-unit seals, gaskets, valves. Boards, grinder burrs, and pumps we order per machine since they vary by line. We confirm stocked versus sourced first.
What does a repair cost?

Diagnostic is $75 and we waive it when you book the repair. You get a written quote before any work, so the number is set before we start.

Need Jura service in Newark?

Tell us what is broken. We will quote it.