How soon can you get to Moraga?

Usually same day. Moraga is one of our closer towns, about a 20 to 25 minute drive from San Ramon through Lafayette. We hold after-hours slots for a cafe or campus machine that needs to run by morning.

Do you stock parts or source them?

Wear parts ride on the van, brew-unit gaskets, seals, common valves. Grinder burrs and boards we order per machine. We confirm stocked versus sourced before any work.

What does a repair cost?

The $75 diagnostic is waived when you go ahead with the repair, and you get a written quote before we start. No charges show up that you did not approve.

JURA · MORAGA

Service · All Jura Models

Jura Commercial Coffee Machine Repair · Moraga, CA

Jura coffee machine repair for Moraga offices, campus, and cafes.

$75 diagnostic (waived with repair)
Same-day best effort
CSLB #1136642

Call (925) 999-4095

Jura in Moraga

Jura commercial service.

Moraga is smaller and quieter, built around the Rheem Valley and Moraga Center shopping districts, 94556, plus the Saint Mary's College campus. The cafes and the campus dining side run Jura super-automatics, and there are plenty of home-office and small-office machines tucked into the hills here too.

We are right next door in San Ramon, about a 20 to 25 minute drive over through Lafayette. That makes Moraga one of our closer runs, so same-day service is usually no problem. We service Jura independently, CSLB #1136642 for the electrical and water-line work.

Common repairs we do

What we close on the truck.

Brew unit wear and gaskets. Lower-volume Moraga machines still wear the brew unit over time, just slower. We rebuild or replace the unit on WE8 and X-line machines and reseat the gaskets.
Descaling for hard-water lines. Lamorinda water leaves scale in the thermoblock and ceramic valves. We do a full descale, check the heater, and fit filtration so a cafe or campus machine stays consistent.
Ceramic valves and drainage. Grounds and scale clog the ceramic valve and drain path, causing puddles and weak flow. We pull the valve, clean the assembly, and clear the drainage.
Ceramic grinder and dose. When the cup goes thin or the grinder labors, the ceramic burrs need attention. We clear and inspect the grinder, then reset grind and dose.

Models we service

Jura product lines.

GIGA X3 and X8 Professional
X8 and X10
WE8

Pricing and warranty

What it costs. What we stand behind.

$75

Diagnostic visit. Waived when you book the repair with us.
1 yr

Parts and labor warranty on completed repairs. In writing before we start.
CSLB

#1136642. Bonded and insured. We file warranty paperwork when applicable.

Nearby cities

Jura service in neighboring cities.

FAQ

Jura in Moraga questions, answered.

How soon can you get to Moraga?

Usually same day. Moraga is one of our closer towns, about a 20 to 25 minute drive from San Ramon through Lafayette. We hold after-hours slots for a cafe or campus machine that needs to run by morning.
Do you stock parts or source them?

Wear parts ride on the van, brew-unit gaskets, seals, common valves. Grinder burrs and boards we order per machine. We confirm stocked versus sourced before any work.
What does a repair cost?

The $75 diagnostic is waived when you go ahead with the repair, and you get a written quote before we start. No charges show up that you did not approve.

Need Jura service in Moraga?

Tell us what is broken. We will quote it.