What is the response time to Mountain View?

Roughly 45 minutes from San Ramon. Downtown and office bars lose a lot of sales when a machine dies, so we run after-hours calls for shops that are fully down.

Do you stock the parts or order them?

Wear items, gaskets, seals, and solenoid parts are on the van. Slayer specific parts like needle valve internals, pumps, and control boards are sourced through Slayer.

How does pricing work?

Diagnostic is $75 and it comes off the bill when you approve the repair. We hand you a written quote first with parts and labor listed before any work.

SLAYER · MOUNTAIN VIEW

Service · All Slayer Models

Slayer Commercial Coffee Machine Repair · Mountain View, CA

Slayer espresso machine repair for Castro Street cafes and Mountain View office bars.

$75 diagnostic (waived with repair)
Same-day best effort
CSLB #1136642

Call (925) 999-4095

Slayer in Mountain View

Slayer commercial service.

Mountain View has one of the denser specialty coffee scenes around, from the Castro Street cafes downtown to the tech office coffee bars across 94040, 94041, and 94043. These Slayer machines pull serious volume on plumbed lines, and high throughput plus unfiltered water is what wears the needle valves and scales the boilers.

We come in from San Ramon, about 45 minutes down 680 and across 237. We work as an independent shop and do not claim Slayer certification. Every repair starts with a written quote, and the $75 diagnostic is waived once you green-light the work.

Common repairs we do

What we close on the truck.

High-volume needle valve service. On a Castro Street bar the needle valve cycles all day, so wear and scale change the flow profile quickly. We rebuild the valve and actuator to bring profiling back to spec.
Pump and pressure repair. Heavy use kills pumps, and you feel it as flat shots and dropping pressure mid-rush. We test the pump under load and replace it when it cannot hold.
Brew and steam solenoids. Constant cycling and scale wear out the brew and steam solenoids, leaving dripping wands or no shot. We rebuild or replace them and clear the lines.
Control board and probe diagnosis. Temperature swings or a machine that will not boot often point to the board or a fouled probe. We diagnose, descale, and source the board or probe through Slayer when needed.

Models we service

Slayer product lines.

Slayer Espresso (1, 2, 3 group)
Single Group
Steam EP/LP/X

Pricing and warranty

What it costs. What we stand behind.

$75

Diagnostic visit. Waived when you book the repair with us.
1 yr

Parts and labor warranty on completed repairs. In writing before we start.
CSLB

#1136642. Bonded and insured. We file warranty paperwork when applicable.

Nearby cities

Slayer service in neighboring cities.

FAQ

Slayer in Mountain View questions, answered.

What is the response time to Mountain View?

Roughly 45 minutes from San Ramon. Downtown and office bars lose a lot of sales when a machine dies, so we run after-hours calls for shops that are fully down.
Do you stock the parts or order them?

Wear items, gaskets, seals, and solenoid parts are on the van. Slayer specific parts like needle valve internals, pumps, and control boards are sourced through Slayer.
How does pricing work?

Diagnostic is $75 and it comes off the bill when you approve the repair. We hand you a written quote first with parts and labor listed before any work.

Need Slayer service in Mountain View?

Tell us what is broken. We will quote it.