SLAYER · HAYWARD
Service · All Slayer ModelsSlayer Commercial Coffee Machine Repair · Hayward, CA
Slayer espresso machine repair for Hayward's downtown and Mission Boulevard cafes.
- $75 diagnostic (waived with repair)
- Same-day best effort
- CSLB #1136642
Slayer in Hayward
Slayer commercial service.
Hayward's coffee runs through the downtown B Street and Foothill cafes and the shops strung along Mission Boulevard, with more out toward the South Hayward and 94544 blocks. The Slayer machines we service here sit in independent espresso bars and a few college-adjacent shops near Cal State East Bay, all plumbed into city water that scales a boiler if the filtration is not kept up.
From San Ramon it is roughly 30 to 40 minutes via 680 to 238 into the 94541 area. We bring a written quote before any work, and the $75 diagnostic is waived once you book the repair.
Common repairs we do
What we close on the truck.
- Descaling and filtration. Hayward city water scales the brew boiler when filtration lags. We descale the machine and the brew path and set up filtration sized to the supply.
- Brew and steam solenoids. When a group won't dose or steam won't shut off, the solenoid is the culprit. We test and replace the brew or steam solenoid and check the timing.
- Needle valve flow profiling. The Slayer ramp depends on a clean needle valve. If pre-infusion goes weak, we clean or rebuild the valve and actuator to restore the profile.
- Control board and probe diagnosis. Erratic behavior or a heat fault points to the control board or boiler probe. We diagnose both, and source the board through Slayer when it needs replacing.
Models we service
Slayer product lines.
- Slayer Espresso (1, 2, 3 group)
- Single Group
- Steam EP/LP/X
Pricing and warranty
What it costs. What we stand behind.
-
$75
Diagnostic visit. Waived when you book the repair with us.
-
1 yr
Parts and labor warranty on completed repairs. In writing before we start.
-
CSLB
#1136642. Bonded and insured. We file warranty paperwork when applicable.
Nearby cities
Slayer service in neighboring cities.
More cities
Slayer across our service area.
- Slayer in Alameda
- Slayer in Alamo
- Slayer in Atherton
- Slayer in Berkeley
- Slayer in Blackhawk
- Slayer in Concord
- Slayer in Cupertino
- Slayer in Danville
- Slayer in Dublin
- Slayer in Fremont
- Slayer in Hillsborough
- Slayer in Lafayette
- Slayer in Livermore
- Slayer in Los Altos
- Slayer in Los Altos Hills
- Slayer in Los Gatos
- Slayer in Martinez
- Slayer in Menlo Park
- Slayer in Milpitas
- Slayer in Moraga
- Slayer in Mountain View
- Slayer in Newark
- Slayer in Oakland
- Slayer in Orinda
- Slayer in Palo Alto
- Slayer in Piedmont
- Slayer in Pleasant Hill
- Slayer in Pleasanton
- Slayer in Richmond
- Slayer in San Jose
- Slayer in San Ramon
- Slayer in Santa Clara
- Slayer in Saratoga
- Slayer in Sunnyvale
- Slayer in Walnut Creek
FAQ
Slayer in Hayward questions, answered.
-
How quickly can you reach Hayward?
Usually same day or next morning, 30 to 40 minutes from San Ramon via 680 and 238. We take after-hours calls, because a dead machine costs a cafe every sale until it is back up. -
Do you stock the parts or order them?
Solenoids, gaskets, and filtration media we keep on hand. Needle valve internals, control boards, and other boutique Slayer parts we order through Slayer. -
What does a repair typically cost?
You get a written quote before any work begins, and the $75 diagnostic is waived when you book the repair.
Need Slayer service in Hayward?