What is your response time to Menlo Park?

Plan on 40 to 45 minutes from San Ramon. When a cafe is fully down and losing sales we take after-hours calls. Tell us it is an emergency and we prioritize it.

Are parts on the truck or ordered in?

Gaskets, seals, and solenoid parts ride on the van. Slayer specific items like needle valve internals, boards, and probes come through Slayer, which adds a day or two depending on stock.

How is pricing handled?

The $75 diagnostic is waived when you go ahead with the repair. You get a written quote first with parts and labor listed, so you decide before we start.

SLAYER · MENLO PARK

Service · All Slayer Models

Slayer Commercial Coffee Machine Repair · Menlo Park, CA

Slayer espresso machine repair for Menlo Park cafes and corporate coffee bars.

$75 diagnostic (waived with repair)
Same-day best effort
CSLB #1136642

Call (925) 999-4095

Slayer in Menlo Park

Slayer commercial service.

Menlo Park keeps Slayer machines busy from the Santa Cruz Avenue cafes downtown out to the Sand Hill Road and Bohannon office coffee bars in 94025 and 94027. The specialty shops here pull a lot of volume, and a high-end machine on a plumbed line takes a beating when the water is not filtered properly.

We drive in from San Ramon, roughly 40 to 45 minutes across the Dumbarton, and we work as an independent shop, not a Slayer authorized dealer. Every job starts with a written quote, and the $75 diagnostic comes off the bill once you approve the repair.

Common repairs we do

What we close on the truck.

Needle valve flow profiling. On a busy Menlo Park bar the needle valve gets a workout, and scale or wear changes the profile baristas rely on. We service the valve and actuator so the ramp and pressure come back to spec.
Pump and pressure problems. Weak or noisy pumps show up as flat shots and inconsistent pressure during a rush. We test the pump under load and replace it when it can no longer hold pressure.
Control board diagnosis. Erratic temperature, dead displays, or a machine that will not start often trace back to the control board. We diagnose the board and source it through Slayer when it needs replacing.
Descaling and water filtration. Office and high-volume bars in 94025 build scale fast without good filtration. We descale the boiler and group and set up a filter so the needle valve and solenoids stay clean.

Models we service

Slayer product lines.

Slayer Espresso (1, 2, 3 group)
Single Group
Steam EP/LP/X

Pricing and warranty

What it costs. What we stand behind.

$75

Diagnostic visit. Waived when you book the repair with us.
1 yr

Parts and labor warranty on completed repairs. In writing before we start.
CSLB

#1136642. Bonded and insured. We file warranty paperwork when applicable.

Nearby cities

Slayer service in neighboring cities.

FAQ

Slayer in Menlo Park questions, answered.

What is your response time to Menlo Park?

Plan on 40 to 45 minutes from San Ramon. When a cafe is fully down and losing sales we take after-hours calls. Tell us it is an emergency and we prioritize it.
Are parts on the truck or ordered in?

Gaskets, seals, and solenoid parts ride on the van. Slayer specific items like needle valve internals, boards, and probes come through Slayer, which adds a day or two depending on stock.
How is pricing handled?

The $75 diagnostic is waived when you go ahead with the repair. You get a written quote first with parts and labor listed, so you decide before we start.

Need Slayer service in Menlo Park?

Tell us what is broken. We will quote it.