How soon can you come to Alamo?

Often same day. Alamo is about 10 minutes from San Ramon, so we're close. After-hours is available if a shop machine goes down during service.

Do you carry Slayer parts?

Seals, gaskets, and solenoids are on the truck. Needle valve internals, control boards, and boiler elements are sourced through Slayer and take a few days.

The $75 diagnostic is waived when you go ahead with the repair. We give a written quote first, before we touch the machine.

SLAYER · ALAMO

Service · All Slayer Models

Slayer Commercial Coffee Machine Repair · Alamo, CA

Slayer espresso machine repair for Alamo, from Alamo Plaza to the Stone Valley shops.

$75 diagnostic (waived with repair)
Same-day best effort
CSLB #1136642

Call (925) 999-4095

Slayer in Alamo

Slayer commercial service.

Alamo's coffee runs through Alamo Plaza and the small commercial cluster off Stone Valley Road in 94507, where a handful of cafes and a couple of high-end home setups run Slayer Espresso machines. The town leans residential and upscale, so we see Single Group and 1 group machines as much as full cafe rigs.

Alamo is about 10 minutes from our San Ramon shop, straight up Danville Boulevard. That short drive means we can swing by for a flow problem or a leak and have most of it sorted on one visit.

Common repairs we do

What we close on the truck.

Single Group flow profiling. On a Slayer Single Group, the needle valve is the whole point. We rebuild the brew needle valve and actuator so the pre-brew and profiling come back the way they should.
Group seals and gaskets. A machine that pulls a few shots a day still loses its seals to scale and age. We swap group seals and gaskets so the shot stops weeping at the head.
Pump and pressure. Soft or noisy extraction usually means the pump. We test pressure and replace the pump if it's worn, then verify the flow profile holds.
Descaling on the home water line. Alamo's plumbed lines vary house to house. We descale the boiler and lines and look at filtration so a low-volume Slayer doesn't scale up between uses.

Models we service

Slayer product lines.

Slayer Espresso (1, 2, 3 group)
Single Group
Steam EP/LP/X

Pricing and warranty

What it costs. What we stand behind.

$75

Diagnostic visit. Waived when you book the repair with us.
1 yr

Parts and labor warranty on completed repairs. In writing before we start.
CSLB

#1136642. Bonded and insured. We file warranty paperwork when applicable.

Nearby cities

Slayer service in neighboring cities.

FAQ

Slayer in Alamo questions, answered.

How soon can you come to Alamo?

Often same day. Alamo is about 10 minutes from San Ramon, so we're close. After-hours is available if a shop machine goes down during service.
Do you carry Slayer parts?

Seals, gaskets, and solenoids are on the truck. Needle valve internals, control boards, and boiler elements are sourced through Slayer and take a few days.
What will it cost?

The $75 diagnostic is waived when you go ahead with the repair. We give a written quote first, before we touch the machine.

Need Slayer service in Alamo?

Tell us what is broken. We will quote it.