SLAYER · MORAGA
Service · All Slayer ModelsSlayer Commercial Coffee Machine Repair · Moraga, CA
Slayer espresso machine repair for Moraga cafes and the Saint Mary's coffee crowd.
- $75 diagnostic (waived with repair)
- Same-day best effort
- CSLB #1136642
Slayer in Moraga
Slayer commercial service.
Moraga is small, but the cafes at the Rheem Center and the Moraga Center plaza, plus the coffee that feeds the Saint Mary's College crowd, run real Slayer machines in 94556. These are quieter shops than a downtown bar, and the issue is usually scale building up slowly on a plumbed line that nobody filtered.
San Ramon to Moraga is about 20 minutes over the hill, so this is close work for us. We are an independent repair shop, not Slayer authorized, and we put a written quote in your hand before any work. The $75 diagnostic is waived when the repair goes ahead.
Common repairs we do
What we close on the truck.
- Needle valve and actuator. On a lower volume machine the needle valve still scales over time and the profile drifts. We service the valve and actuator so flow control is sharp again.
- Descaling and filtration setup. Shops in 94556 that skip filtration build scale in the boiler and valves. We descale the machine and put a proper water filter in line to keep it from recurring.
- Boiler element and probe. When a machine sits and sees lighter use, a scaled element and probe cause slow heating and odd temperatures. We test both and replace what is failed.
- Group seals and brew solenoid. Aging group gaskets leak and a sticky brew solenoid leaves you with no shot. We replace seals and rebuild or swap the brew solenoid.
Models we service
Slayer product lines.
- Slayer Espresso (1, 2, 3 group)
- Single Group
- Steam EP/LP/X
Pricing and warranty
What it costs. What we stand behind.
-
$75
Diagnostic visit. Waived when you book the repair with us.
-
1 yr
Parts and labor warranty on completed repairs. In writing before we start.
-
CSLB
#1136642. Bonded and insured. We file warranty paperwork when applicable.
Nearby cities
Slayer service in neighboring cities.
More cities
Slayer across our service area.
- Slayer in Alameda
- Slayer in Alamo
- Slayer in Atherton
- Slayer in Berkeley
- Slayer in Blackhawk
- Slayer in Castro Valley
- Slayer in Concord
- Slayer in Cupertino
- Slayer in Danville
- Slayer in Dublin
- Slayer in Fremont
- Slayer in Hayward
- Slayer in Hillsborough
- Slayer in Livermore
- Slayer in Los Altos
- Slayer in Los Altos Hills
- Slayer in Los Gatos
- Slayer in Martinez
- Slayer in Menlo Park
- Slayer in Milpitas
- Slayer in Mountain View
- Slayer in Newark
- Slayer in Oakland
- Slayer in Palo Alto
- Slayer in Piedmont
- Slayer in Pleasant Hill
- Slayer in Pleasanton
- Slayer in Richmond
- Slayer in San Jose
- Slayer in San Leandro
- Slayer in San Ramon
- Slayer in Santa Clara
- Slayer in Saratoga
- Slayer in Sunnyvale
- Slayer in Union City
FAQ
Slayer in Moraga questions, answered.
-
How soon can you get to Moraga?
About 20 minutes from San Ramon, so Moraga is close work. A dead machine costs a cafe its morning, and we take after-hours calls when a shop is down. -
Will you have the parts with you?
Gaskets, seals, and solenoid rebuild parts are on the van. Slayer specific parts such as needle valve internals, probes, and boards come through Slayer and take a bit longer. -
How much should I expect to pay?
The $75 diagnostic is waived when you approve the repair. You get a written quote first with parts and labor itemized before we start any work.
Need Slayer service in Moraga?