How quickly can you get to Danville?

Fast. We are 10 to 15 minutes away in San Ramon, so usually same day. We also take after-hours calls, since a downtown cafe with a dead machine is losing sales by the hour.

Do you keep Slayer parts on hand?

We stock the everyday wear items, gaskets, solenoids, and descaling supplies. Needle valve internals and control boards come through Slayer, so those we order in.

What does a typical repair run?

Every job gets a written quote up front, and the $75 diagnostic is waived when you book the repair.

SLAYER · DANVILLE

Service · All Slayer Models

Slayer Commercial Coffee Machine Repair · Danville, CA

Slayer espresso machine repair for Danville's downtown cafes and roaster bars.

$75 diagnostic (waived with repair)
Same-day best effort
CSLB #1136642

Call (925) 999-4095

Slayer in Danville

Slayer commercial service.

Danville's coffee runs through the Hartz Avenue shops downtown and the cafes tucked into the Town and Country and Blackhawk Plaza centers. The Slayer machines here tend to be single group and 2 group units in tight, busy independent rooms in 94526, with a few out toward the 94506 side. These are small-footprint bars where one dead machine stops service cold.

Danville is close, about 10 to 15 minutes from San Ramon down 680. We hand you a written quote before any work, and the $75 diagnostic is waived when you book the repair.

Common repairs we do

What we close on the truck.

Single Group needle valve service. On a Slayer Single Group the needle valve does all the profiling work. When the ramp feels off or the lever binds, we clean or rebuild the valve and actuator.
Group seals and gaskets. A drip or a weak seal on the group head is the most common call on a busy small bar. We replace the group seals and gaskets so the portafilter locks tight.
Descaling and filtration. Plumbed-in machines build scale fast without the right filter. We descale the brew boiler and brew path and tune the water filtration for the local supply.
Control board diagnosis. When the machine acts erratic or won't power through its cycle, the control board is the suspect. We diagnose it, and source the board through Slayer when it needs replacing.

Models we service

Slayer product lines.

Slayer Espresso (1, 2, 3 group)
Single Group
Steam EP/LP/X

Pricing and warranty

What it costs. What we stand behind.

$75

Diagnostic visit. Waived when you book the repair with us.
1 yr

Parts and labor warranty on completed repairs. In writing before we start.
CSLB

#1136642. Bonded and insured. We file warranty paperwork when applicable.

Nearby cities

Slayer service in neighboring cities.

FAQ

Slayer in Danville questions, answered.

How quickly can you get to Danville?

Fast. We are 10 to 15 minutes away in San Ramon, so usually same day. We also take after-hours calls, since a downtown cafe with a dead machine is losing sales by the hour.
Do you keep Slayer parts on hand?

We stock the everyday wear items, gaskets, solenoids, and descaling supplies. Needle valve internals and control boards come through Slayer, so those we order in.
What does a typical repair run?

Every job gets a written quote up front, and the $75 diagnostic is waived when you book the repair.

Need Slayer service in Danville?

Tell us what is broken. We will quote it.