How fast can you get to a cafe in Oakland?

Most Oakland calls get a same-day or next-morning slot, 35 to 45 minutes from San Ramon. A dead machine costs a cafe every shot, so we run after-hours and early-open visits when a bar is down.

Do you stock Faema parts or have to order them?

We carry the common E61 gaskets, seals, and solenoid kits on the van. Line-specific control boards, level probes, and boiler elements we source from La Cimbali group supply, usually in a day or two.

What does a Faema repair typically cost?

The diagnostic is $75, waived when you book the repair. You get a written quote before any work starts. Most jobs are a group rebuild, a solenoid, or a descale and element, and we price each in writing first.

FAEMA · OAKLAND

Service · All Faema Models

Faema Commercial Coffee Machine Repair · Oakland, CA

Independent Faema espresso machine repair for Oakland cafes and roasters.

$75 diagnostic (waived with repair)
Same-day best effort
CSLB #1136642

Call (925) 999-4095

Faema in Oakland

Faema commercial service.

Oakland runs on third-wave coffee, and a lot of those shops along Temescal and up Piedmont Avenue (94609, 94610) pull shots on Italian iron like Faema. When an E61 group starts dripping or a boiler loses pressure mid-rush, the bar stops earning. We service Faema as an independent shop, no factory badge, just techs who know the E61 brew group Faema invented and the heat-exchanger and multi-boiler machines built around it.

From San Ramon we reach Oakland in roughly 35 to 45 minutes depending on the 24 and the 13. Temescal, Grand Lake near the lake in 94610, and the Dimond around 94602 are all on our regular route. We carry the common E61 wear parts and source line-specific boards and solenoids fast when a machine needs them.

Common repairs we do

What we close on the truck.

E61 group gaskets and seals. Faema invented the E61 group, and its gaskets and seals are the most common drip and pressure-loss failure. We pull the group, replace the gaskets, and reset the lever so it sits clean.
Brew and steam solenoid valves. A solenoid that sticks gives you a dribbling group or a steam wand that won't shut. We test the coil and valve, then rebuild or replace it on E61 Legend, Jubile, Teorema, and Emblema.
Heat-exchanger descaling and element. Oakland water leaves scale in the heat exchanger and on the element, which kills recovery and trips the machine. We descale, test the element, and check your water filtration so it doesn't come back fast.
Pump and level probe faults. Low pressure or an autofill that won't stop usually traces to a tired pump or a scaled level probe. We bench the pump, clean or swap the probe, and confirm the control board is reading it right.

Models we service

Faema product lines.

E71
E61 Legend and Jubile
Teorema and Emblema

Pricing and warranty

What it costs. What we stand behind.

$75

Diagnostic visit. Waived when you book the repair with us.
1 yr

Parts and labor warranty on completed repairs. In writing before we start.
CSLB

#1136642. Bonded and insured. We file warranty paperwork when applicable.

Nearby cities

Faema service in neighboring cities.

FAQ

Faema in Oakland questions, answered.

How fast can you get to a cafe in Oakland?

Most Oakland calls get a same-day or next-morning slot, 35 to 45 minutes from San Ramon. A dead machine costs a cafe every shot, so we run after-hours and early-open visits when a bar is down.
Do you stock Faema parts or have to order them?

We carry the common E61 gaskets, seals, and solenoid kits on the van. Line-specific control boards, level probes, and boiler elements we source from La Cimbali group supply, usually in a day or two.
What does a Faema repair typically cost?

The diagnostic is $75, waived when you book the repair. You get a written quote before any work starts. Most jobs are a group rebuild, a solenoid, or a descale and element, and we price each in writing first.

Need Faema service in Oakland?

Tell us what is broken. We will quote it.