Do you cover Daly City directly, or are you coming from San Ramon every time?

Our Peninsula technician lives in San Mateo County and runs calls up through Daly City, South San Francisco, and Brisbane as part of a normal route, not a special trip. That keeps the drive short and scheduling easier than routing everyone through San Ramon.

What's the cost to have someone look at a dead machine?

The diagnostic is $99. If you approve the repair, that $99 is credited toward the repair, and you get a written quote before any parts get ordered.

Do you stock Eversys parts?

Seals, gaskets, and filters ride on the van. Boards, pumps, and grinder assemblies I order once the diagnostic confirms what failed, and the quote lists the part before I place it.

EVERSYS · DALY CITY

Service · All Eversys Models

Eversys Commercial Coffee Machine Repair · Daly City, CA

Eversys commercial coffee machine repair in Daly City, where the fog off Westlake and Serramonte never really lifts.

$99 diagnostic (credited toward the repair)
Same or next-day best effort
CSLB #1136642

Call (925) 999-4095

Eversys in Daly City

Eversys commercial service.

Daly City sits under fog most of the year, and every cafe, hotel lobby, and office break room from Westlake to the Top of the Hill runs coffee service through it. Serramonte Center and the shops along Mission Street lean on Eversys e-series and Cameo machines to pour espresso and milk drinks all day without a trained barista behind the counter. We also cover Brisbane just over the hill, since it sits inside the same short drive.

We do not carry factory authorization, and we are upfront about that. What we bring is time inside these cabinets: the brew groups, the twin grinders, the volumetric flow meters, and the milk systems that make an Eversys different from a plain drip setup.

The diagnostic is $99 and it is credited toward the repair. You get a written quote before we touch anything, CSLB #1136642 covers the licensed work, and we're out here seven days a week.

Common repairs we do

What we close on the truck.

Control board condensation faults. Daly City's marine layer puts real moisture into a machine sitting near an exterior door or a drafty stockroom. I've opened Eversys control enclosures here and found corrosion starting on connector pins from years of damp air cycling through. I clean and reseat the connections, dry out the enclosure, and where the corrosion has gone too far, replace the board.
Twin grinder dose drift. The e-series pulls its two blends through separate grinders, and burrs wear faster on a machine covering two shifts of retail traffic near Serramonte. When a shot comes out thin or the timer runs long, I check burr wear first, swap them, and recalibrate the dose so both hoppers pour even.
Volumetric flow meter errors. A flow meter throwing under-pour or over-pour faults usually points to scale or a failing meter body, not the control board. I test the meter against a manual pour, replace it if it's reading wrong, and check the water line feeding it before closing the machine back up.

Models we service

Eversys product lines.

e-series (e2, e4, e6)
c-series (c2, c4)
Shotmaster
Cameo and Legacy

Pricing and warranty

What it costs. What we stand behind.

$99

Diagnostic visit. Credited toward the repair.
Written

3 months standard, 1 year on inverter boards, up to 2 years on sealed-system rebuilds. Quoted in writing before work starts.
CSLB

#1136642. Bonded and insured. We file warranty paperwork when applicable.

Recent work

Eversys jobs we have closed.

Martinez, CA · Eversys super-automatic espresso machine

Eversys Shotmaster Bean Hopper Fault Fixed in Martinez

The Shotmaster kept reading the left bean hopper as empty or locked even with beans in it, which locked staff out of pulling any drinks.
Read case →

See all case studies →

Nearby cities

Eversys service in neighboring cities.

More cities

Eversys across our service area.

FAQ

Eversys in Daly City questions, answered.

Do you cover Daly City directly, or are you coming from San Ramon every time?

Our Peninsula technician lives in San Mateo County and runs calls up through Daly City, South San Francisco, and Brisbane as part of a normal route, not a special trip. That keeps the drive short and scheduling easier than routing everyone through San Ramon.
What's the cost to have someone look at a dead machine?

The diagnostic is $99. If you approve the repair, that $99 is credited toward the repair, and you get a written quote before any parts get ordered.
Do you stock Eversys parts?

Seals, gaskets, and filters ride on the van. Boards, pumps, and grinder assemblies I order once the diagnostic confirms what failed, and the quote lists the part before I place it.

Need Eversys service in Daly City?

Tell us what is broken. We will quote it.