How fast can you get to a cafe in Alameda?

Same day or next morning in most cases, about 40 minutes from San Ramon over the bridge. We do after-hours and early calls too, since a dead machine means no espresso sales the second you open.

Do you stock Synesso parts or have to order them?

We carry common wear parts on the van, group gaskets, solenoid rebuild kits, and flow meters. Boards and specific boiler elements we source from our suppliers, usually a day or two out.

What does a repair run?

Diagnostic is $75 and it's waived when you book the repair. You get a written quote before we touch anything, so there's no surprise on the invoice.

SYNESSO · ALAMEDA

Service · All Synesso Models

Synesso Commercial Coffee Machine Repair · Alameda, CA

Independent Synesso espresso machine repair for cafes across Alameda.

$75 diagnostic (waived with repair)
Same-day best effort
CSLB #1136642

Call (925) 999-4095

Synesso in Alameda

Synesso commercial service.

Plenty of Alameda's third-wave shops run Synesso. We service the cafes along Park Street and Webster Street, plus the roasters and counters scattered through the West End in 94501 and the Bay Farm side in 94502. Synesso's per-group setup is built for the volume those rooms push on a Saturday, and it holds up when the water is right.

We come over the San Mateo or Bay Bridge from San Ramon, roughly 40 minutes off-peak. Island water is hard on plumbed machines, so most of what we pull apart here traces back to scale. We descale, check your filtration, and tell you straight if the cartridge is shot before it kills a boiler element.

Common repairs we do

What we close on the truck.

Per-group solenoid and gasket service. A leaking or stuck group solenoid throws off shot timing on an MVP Hydra or S-series. We rebuild the valve and swap the group gaskets so each head dispenses clean.
Boiler element and PID per group. Scale from hard island water fouls a group boiler element and the PID loses its set point. We pull the element, descale the boiler, and verify the per-group temperature is stable again.
Flow meter and volumetric dosing. When volumetric doses drift, a clogged flow meter is usually the cause. We clean or replace the meter so each programmed shot pours the same volume twice running.
Pump and motor rebuild. Pressure dropping mid-service points at the pump or motor. We test line pressure, rebuild or replace the pump, and check the inlet so the machine holds brew pressure under load.

Models we service

Synesso product lines.

MVP Hydra
S-series (S200/S300)
ES1

Pricing and warranty

What it costs. What we stand behind.

$75

Diagnostic visit. Waived when you book the repair with us.
1 yr

Parts and labor warranty on completed repairs. In writing before we start.
CSLB

#1136642. Bonded and insured. We file warranty paperwork when applicable.

Nearby cities

Synesso service in neighboring cities.

FAQ

Synesso in Alameda questions, answered.

How fast can you get to a cafe in Alameda?

Same day or next morning in most cases, about 40 minutes from San Ramon over the bridge. We do after-hours and early calls too, since a dead machine means no espresso sales the second you open.
Do you stock Synesso parts or have to order them?

We carry common wear parts on the van, group gaskets, solenoid rebuild kits, and flow meters. Boards and specific boiler elements we source from our suppliers, usually a day or two out.
What does a repair run?

Diagnostic is $75 and it's waived when you book the repair. You get a written quote before we touch anything, so there's no surprise on the invoice.

Need Synesso service in Alameda?

Tell us what is broken. We will quote it.