How quickly can you reach Blackhawk, including after hours?

Blackhawk is about 15 minutes from our San Ramon shop, so we are usually on site same day. A dead machine in a club or at the Plaza means lost service, so we take after-hours calls when a unit is fully down.

Do you carry Franke parts or order them?

Wear items, brewer seals, FoamMaster valves, burrs, and descaler, we keep stocked. Boards, touchscreens, flow meters, and pumps we order from suppliers, usually a few days. We confirm which before starting.

What is the typical repair cost?

The diagnostic is $75 and waived when you go ahead with the repair. We provide a written quote before any work, so a descaling or milk-system job is priced and approved in advance.

FRANKE · BLACKHAWK

Service · All Franke Models

Franke Commercial Coffee Machine Repair · Blackhawk, CA

Franke coffee machine repair for Blackhawk Plaza, clubs, and offices, 94506.

$75 diagnostic (waived with repair)
Same-day best effort
CSLB #1136642

Call (925) 999-4095

Franke in Blackhawk

Franke commercial service.

Blackhawk's commercial coffee runs through Blackhawk Plaza and the club, country club, and office settings inside the gates. These are polished, lower-to-mid-volume spots where a Franke super-automatic serves members, diners, and staff, and where a machine sitting dead in front of guests is not acceptable. A600 units fit this kind of service well.

Blackhawk is close to home for us, about 15 minutes from San Ramon up Camino Tassajara into 94506. That short drive makes it one of our fastest response areas. We service Franke independently, not as an authorized dealer, with a written quote before work. The plumbed water line here scales like anywhere in the valley, so descaling and filtration lead most diagnoses.

Common repairs we do

What we close on the truck.

Descaling and water filtration. Scale off the plumbed line at the Plaza or club drops temperature and pressure. We descale the boiler circuit and set an inline filter so an A600 holds its brew quality for members.
FoamMaster milk system service. Cappuccinos and flat whites for a club dining room mean the FoamMaster has to be spotless. We rebuild valves, flush lines, and reset the injector for clean foam.
Brewer unit and seal replacement. Weak shots or grounds in the cup trace to the brew group. We replace seals, clean the piston, and get extraction even again.
Touchscreen and control board repair. A frozen panel takes the whole machine offline in front of guests. We test the touchscreen and control board, reseat connections, and source the part when it needs replacing.

Models we service

Franke product lines.

A300, A600, A800
SB1200
Mytico

Pricing and warranty

What it costs. What we stand behind.

$75

Diagnostic visit. Waived when you book the repair with us.
1 yr

Parts and labor warranty on completed repairs. In writing before we start.
CSLB

#1136642. Bonded and insured. We file warranty paperwork when applicable.

Nearby cities

Franke service in neighboring cities.

FAQ

Franke in Blackhawk questions, answered.

How quickly can you reach Blackhawk, including after hours?

Blackhawk is about 15 minutes from our San Ramon shop, so we are usually on site same day. A dead machine in a club or at the Plaza means lost service, so we take after-hours calls when a unit is fully down.
Do you carry Franke parts or order them?

Wear items, brewer seals, FoamMaster valves, burrs, and descaler, we keep stocked. Boards, touchscreens, flow meters, and pumps we order from suppliers, usually a few days. We confirm which before starting.
What is the typical repair cost?

The diagnostic is $75 and waived when you go ahead with the repair. We provide a written quote before any work, so a descaling or milk-system job is priced and approved in advance.

Need Franke service in Blackhawk?

Tell us what is broken. We will quote it.