ELMECO · MILPITAS
Service · All Elmeco ModelsElmeco Frozen Beverage Machine Repair · Milpitas, CA
Elmeco frozen beverage and slush machine repair in Milpitas, on-site service for granita and frozen-drink equipment.
- $75 diagnostic (waived with repair)
- Same-day best effort
- CSLB #1136642
Elmeco in Milpitas
Elmeco commercial service.
Milpitas runs on foodservice. The Great Mall food court, the Asian restaurants and bakeries along Calaveras and Dixon Landing, and the chains out at McCarthy Ranch all push equipment hard, and an Elmeco granita or frozen-drink machine down on a busy afternoon means lost sales by the hour. We cover the whole 95035 area and the surrounding commercial districts.
We are based in San Ramon, about a 40 minute run down 680 to Milpitas. We service Elmeco Big Biz, First Class, and Quick Gel machines on-site. CSLB #1136642 for any refrigerant or gas work. The $75 diagnostic is waived when you go ahead with the repair, and you get a written quote before we touch anything.
Common repairs we do
What we close on the truck.
- Gearmotor replacement. Worn or seized gearmotors that stall the auger and stop the mix from turning, swapped out and tested.
- Magnetic coupling repair. Slipping or failed magnetic couplings that drive the bowl, the common reason a machine runs but will not churn.
- Bowl gaskets and lid seals. Cracked bowl gaskets and dried lid seals that leak mix or pull in air, replaced to hold a proper freeze.
- Mix sensors and control boards. Faulty mix sensors and electronic boards that throw bad readings or kill the cooling cycle, diagnosed and replaced.
Models we service
Elmeco product lines.
- Big Biz, First Class, and Quick Gel granita machines
Pricing and warranty
What it costs. What we stand behind.
-
$75
Diagnostic visit. Waived when you book the repair with us.
-
1 yr
Parts and labor warranty on completed repairs. In writing before we start.
-
CSLB
#1136642. Bonded and insured. We file warranty paperwork when applicable.
Nearby cities
Elmeco service in neighboring cities.
FAQ
Elmeco in Milpitas questions, answered.
-
How fast can you get to Milpitas?
We are about 40 minutes from San Ramon down 680. Same-day on most calls, and since this is foodservice we take after-hours calls when a machine goes down during service. -
Do you carry Elmeco parts or have to order them?
We stock common wear parts like gaskets, seals, and couplings on the truck. Gearmotors, sensors, and boards are usually sourced from the Elmeco supplier and turned around quick. -
What does a repair typically cost?
The diagnostic is $75 and gets waived when you approve the repair. You get a written quote before any work starts, so the total is set before we begin.
Need Elmeco service in Milpitas?