How quickly can you reach Alamo from your San Ramon base?

Alamo is our shortest run, about 15 minutes straight up 680. We are passing through daily on the way to Danville, Walnut Creek, and Lafayette jobs, so same-day service is realistic most of the week, and we answer 7 days.

Is it worth repairing a home granita machine or should I replace it?

Elmeco builds machines for commercial duty, so a home unit is usually loafing and worth fixing. I will give you a written quote after the $75 diagnostic, which we waive if you go ahead with the repair, and I will tell you plainly if replacement makes more sense.

Can you do a pre-season check before I host a big event?

Yes, and I recommend it. We run the machine to full freeze, check seals, drive noise, and refrigerant performance, and replace anything marginal a week or two before the event instead of the morning of. That visit is scheduled like any service call.

ELMECO · ALAMO

Service · All Elmeco Models

Elmeco Frozen Beverage Machine Repair · Alamo, CA

Elmeco frozen beverage machine repair for Alamo estates and home bars

$75 diagnostic (waived with repair)
Same or next-day best effort
CSLB #1136642

Call (925) 999-4095

Elmeco in Alamo

Elmeco commercial service.

Alamo is not a restaurant town, and that changes what Elmeco service looks like here. Most of the machines we see are in large home kitchens and outdoor entertaining setups along Miranda Avenue and up in Round Hill, where an owner put a First Class unit on the bar for summer parties. A few sit in the small cafes near Alamo Plaza.

Home-installed granita machines fail differently than cafe machines. They sit idle for months, then run flat out for a graduation weekend. Seals dry out during the idle stretch, and the gearmotor takes the shock when a half-frozen bowl gets restarted. I would rather do a pre-season check than a party-day rescue, and we offer exactly that.

We are based in San Ramon, one exit down 680, so Alamo is the closest territory we cover. Written quotes, $75 diagnostic waived with repair, and a 1-year warranty on repair work.

Common repairs we do

What we close on the truck.

Dried bowl gasket after months of storage. A machine that sat in the pool house since October will often leak the day you fill it in June. The bowl gasket and rear seal harden when they are dry, and the first batch of mix finds every gap. We replace the gasket set and lubricate correctly with food-grade grease, which is a quick visit if you book before your event.
Compressor start relay clicking without starting. On home units that cycle rarely, the start relay and capacitor age out quietly. You hear a click, a hum for a few seconds, then silence while the bowl stays warm. Nine times out of ten this is a start-component swap, not a compressor. We test the compressor windings first so you never pay for the big part when the small one is at fault.
Density control drifting so granita comes out wrong. Elmeco consistency adjustment relies on sensing the torque the spiral needs. When it drifts, you get soup at one setting and a frozen block at the next. We recalibrate, check the sensing mechanism, and verify the machine holds texture through a full freeze-down before we leave.

Models we service

Elmeco product lines.

Big Biz, First Class, and Quick Gel granita machines

Pricing and warranty

What it costs. What we stand behind.

$75

Diagnostic visit. Waived when you book the repair with us.
Written

90 days on consumables, 1 year on major parts, 2 years on sealed-system rebuilds. Quoted in writing before work starts.
CSLB

#1136642. Bonded and insured. We file warranty paperwork when applicable.

Nearby cities

Elmeco service in neighboring cities.

FAQ

Elmeco in Alamo questions, answered.

How quickly can you reach Alamo from your San Ramon base?

Alamo is our shortest run, about 15 minutes straight up 680. We are passing through daily on the way to Danville, Walnut Creek, and Lafayette jobs, so same-day service is realistic most of the week, and we answer 7 days.
Is it worth repairing a home granita machine or should I replace it?

Elmeco builds machines for commercial duty, so a home unit is usually loafing and worth fixing. I will give you a written quote after the $75 diagnostic, which we waive if you go ahead with the repair, and I will tell you plainly if replacement makes more sense.
Can you do a pre-season check before I host a big event?

Yes, and I recommend it. We run the machine to full freeze, check seals, drive noise, and refrigerant performance, and replace anything marginal a week or two before the event instead of the morning of. That visit is scheduled like any service call.

Need Elmeco service in Alamo?

Tell us what is broken. We will quote it.