How fast can you be in Lafayette from San Ramon?

About 20 minutes up 680 and over on 24. Lafayette sits between our Alamo, Walnut Creek, and Orinda stops, so we pass through constantly. A machine that dies during morning prep can often be looked at the same day. We answer 7 days.

Will you tell us if the machine is not worth fixing?

Yes, in writing. The quote shows the repair cost next to my honest read on the machine's remaining life. Elmeco builds durable equipment, so most repairs pencil out, but when a compressor and a gearmotor fail together on an old unit I will say so.

How disruptive is a typical repair to our service day?

Seal and tap work takes an hour or two. A gearmotor swap is usually half a day including a verified freeze-down. Sealed-system work takes longer because I test before returning the machine to service. We schedule around your hours, including before open.

ELMECO · LAFAYETTE

Service · All Elmeco Models

Elmeco Frozen Beverage Machine Repair · Lafayette, CA

Elmeco granita machine repair for Lafayette's Mt. Diablo Boulevard restaurants

$75 diagnostic (waived with repair)
Same or next-day best effort
CSLB #1136642

Call (925) 999-4095

Elmeco in Lafayette

Elmeco commercial service.

Lafayette's dining strip along Mt. Diablo Boulevard is compact and busy, and several of its cafes and dessert counters keep Elmeco machines turning frozen lemonade and espresso granita through the warm months. The town also has a healthy population of high-end home kitchens in the hills where we see the occasional residential unit.

Boulevard storefronts here tend to be older buildings with tight back counters and marginal ventilation. That combination shows up in my diagnostic notes as hot condensers and overworked compressors. The drive train complaint that follows is predictable: the gearmotor labors against product that is not freezing right, and the weakest gear loses.

Lafayette is an easy run for us, about 20 minutes from San Ramon up 680 and through the 24 corridor. Written quotes, $75 diagnostic waived with repair, service 7 days a week.

Common repairs we do

What we close on the truck.

Gearmotor whine that turns into a dead spiral. The reduction gear announces wear as a rising whine when the product thickens toward serving texture. Owners get used to the sound, and then one morning the spiral sits still in a frozen bowl. We inspect the gear train at the whine stage whenever we are on site, because replacing a gearmotor on schedule beats replacing it during a heat wave.
Condenser choked in a tight boulevard back counter. Old storefronts put the machine wherever it fits, which is usually against a wall with no breathing room. The condenser plugs with dust, pressures climb, and freezing capacity drops right when summer demand peaks. We deep-clean the coil and reposition or duct the machine when the space allows.
Millennium electronics acting up after summer brownouts. The 24 corridor gets voltage sags on hot afternoons, and the Millennium's control board does not love them. Symptoms range from lost settings to a machine that stops responding until power-cycled. We test the board, replace it when it is genuinely failed, and add basic power protection when it is not.

Models we service

Elmeco product lines.

Big Biz, First Class, and Quick Gel granita machines

Pricing and warranty

What it costs. What we stand behind.

$75

Diagnostic visit. Waived when you book the repair with us.
Written

90 days on consumables, 1 year on major parts, 2 years on sealed-system rebuilds. Quoted in writing before work starts.
CSLB

#1136642. Bonded and insured. We file warranty paperwork when applicable.

Nearby cities

Elmeco service in neighboring cities.

FAQ

Elmeco in Lafayette questions, answered.

How fast can you be in Lafayette from San Ramon?

About 20 minutes up 680 and over on 24. Lafayette sits between our Alamo, Walnut Creek, and Orinda stops, so we pass through constantly. A machine that dies during morning prep can often be looked at the same day. We answer 7 days.
Will you tell us if the machine is not worth fixing?

Yes, in writing. The quote shows the repair cost next to my honest read on the machine's remaining life. Elmeco builds durable equipment, so most repairs pencil out, but when a compressor and a gearmotor fail together on an old unit I will say so.
How disruptive is a typical repair to our service day?

Seal and tap work takes an hour or two. A gearmotor swap is usually half a day including a verified freeze-down. Sealed-system work takes longer because I test before returning the machine to service. We schedule around your hours, including before open.

Need Elmeco service in Lafayette?

Tell us what is broken. We will quote it.