Foster City is a bit removed from your usual routes. Do you actually come out here?

Yes, our Peninsula technician is based in San Mateo, just a few minutes over, so Foster City is on his regular route. We do not promise same-day for every call, but it is not a special trip out from San Ramon.

Do you stock the parts my Elmeco machine needs?

Gasket and seal kits are usually already on the truck. Gearmotors, sensors, and boards depend on your specific Elmeco model, so we source those and give you the timeline up front.

What's the diagnostic charge?

$99, and it is credited toward the repair. You get the quote in writing before we start any work. CSLB #1136642 covers our refrigerant and gas licensing.

ELMECO · FOSTER CITY

Service · All Elmeco Models

Elmeco Frozen Beverage Machine Repair · Foster City, CA

Elmeco frozen beverage and slush machine repair for Foster City's waterfront restaurants and shopping centers along Foster City Boulevard.

$99 diagnostic (credited toward the repair)
Same or next-day best effort
CSLB #1136642

Call (925) 999-4095

Elmeco in Foster City

Elmeco commercial service.

Foster City was built as a planned waterfront community, so most of the frozen beverage machines we service sit in the shopping centers along Foster City Boulevard and Edgewater Place rather than a historic downtown strip. We cover the 94404 zip and the run over to San Mateo, Belmont, and Redwood City.

The restaurants and cafes serving the condos and townhomes around the lagoons run the same Elmeco lines we see across the Peninsula, the Big Biz, First Class, and Quick Gel machines. When one goes down mid-shift, we come out, diagnose the real problem, and hand you a written quote before starting.

Common repairs we do

What we close on the truck.

Bowl gasket and lid seal leaks. Mix leaking from under the bowl or past the lid means the gaskets or seals have dried out. We replace them so the bowl holds pressure and stops dripping onto the counter.
Gearmotor stalling under load. The auger slows down or stops turning when the bowl is full, and the mix stays runny instead of freezing. We test the gearmotor and replace it once the bearings or windings are worn out.
Mix sensor or board failure. The display throws an error or the freeze setting will not hold, and that usually traces to a bad mix sensor or a failed control board. We test both and only replace the part that is actually bad.

Models we service

Elmeco product lines.

Big Biz, First Class, and Quick Gel granita machines

Pricing and warranty

What it costs. What we stand behind.

$99

Diagnostic visit. Credited toward the repair.
Written

3 months standard, 1 year on inverter boards, up to 2 years on sealed-system rebuilds. Quoted in writing before work starts.
CSLB

#1136642. Bonded and insured. We file warranty paperwork when applicable.

Nearby cities

Elmeco service in neighboring cities.

More cities

Elmeco across our service area.

FAQ

Elmeco in Foster City questions, answered.

Foster City is a bit removed from your usual routes. Do you actually come out here?

Yes, our Peninsula technician is based in San Mateo, just a few minutes over, so Foster City is on his regular route. We do not promise same-day for every call, but it is not a special trip out from San Ramon.
Do you stock the parts my Elmeco machine needs?

Gasket and seal kits are usually already on the truck. Gearmotors, sensors, and boards depend on your specific Elmeco model, so we source those and give you the timeline up front.
What's the diagnostic charge?

$99, and it is credited toward the repair. You get the quote in writing before we start any work. CSLB #1136642 covers our refrigerant and gas licensing.

Need Elmeco service in Foster City?

Tell us what is broken. We will quote it.