Our machine is in Crockett. Is that inside your service area?

Yes. Crockett and Port Costa are covered along with Rodeo. We confirm the service arrangement and price when you book and provide a written quote before repair work.

How do we slow down corrosion on a machine near the water?

Keep the condenser clean, since salt and dust hold moisture against the fins. Leave room around the vents, wipe the cabinet down and have the electrical connections checked once a year. Catching green terminals early is far cheaper than chasing random trips later.

Why does our machine trip the breaker on some days and not others?

An intermittent trip can come from a connection that is loose or corroded, a start part that fails once it is warm, or a circuit shared with other equipment. We test the machine and the outlet under load, trace which one it is, then quote the fix in writing.

BUNN · RODEO

Service · All Bunn Models

Bunn Frozen Beverage Machine Repair · Rodeo, CA

Bunn frozen drink and JDF repair in Rodeo, with calls in Crockett and Port Costa taken too.

Bunn equipment connected to the building plumbing is diagnosed on site for $99, credited toward the repair. Countertop units come to our bench; we confirm the bench price when you book.
Same or next-day best effort
CSLB #1136642

Call (925) 999-4095

Bunn in Rodeo

Bunn commercial service.

Rodeo sits on the eastern shore of San Pablo Bay, and a machine near the shoreline lives in damp, salty air. Over time that shows up on a Bunn frozen drink machine as corroded condenser fins, green terminals and relay contacts that stop closing cleanly. We look for it whenever we open a machine here.

Our technician for Rodeo, Crockett and Port Costa is based in Benicia. At the machine we check the electrical connections, the condenser and the sealed system, plus the drive and seals. You see a written quote before anything is replaced. For Bunn connected to the building plumbing, the on-site diagnostic is $99, credited toward repair. We confirm countertop bench pricing when you book.

Common repairs we handle.

Corroded relay and terminal connections. Salt air eats at relay contacts and wire terminals until the compressor or gear motor gets an unsteady supply. The symptoms look random: a machine that trips, restarts or runs only on some days. We clean or replace the corroded parts and tighten every connection in the refrigeration deck.
Condenser fins flattened or corroded. Corroded or bent fins block airflow the same way dirt does, and the compressor pays for it. We clean the coil, straighten what we can and tell you if the condenser has corroded past saving. Replacing it is a sealed-system job, done under ADRIUM's EPA 608 Universal certification.
Auger seal wear on a hard-working Ultra-2. The rear auger seal takes the brunt of long run hours. When it wears, product weeps into the drum area and the machine smells sour however often it is cleaned. We replace the seal and wear ring together and check the shaft for scoring.

Models we service

Bunn product lines.

Ultra-2 and Ultra-NX frozen and granita dispensers
JDF juice and drink units

Pricing and warranty

What it costs. What we stand behind.

Price at booking

Bunn equipment connected to the building plumbing is diagnosed on site for $99, credited toward the repair. Countertop units come to our bench; we confirm the bench price when you book.
Written

Parts and labor, 3 months to 2 years depending on the type of repair. Quoted in writing before work starts.
CSLB

#1136642. Bonded and insured. We file warranty paperwork when applicable.

Recent work

Bunn jobs we have closed.

Union City, CA · Commercial Bean-to-Cup Coffee Machine

Bunn Crescendo Commercial Coffee Machine Repair

A busy Union City location was losing its coffee service. The Crescendo's brew path had worn out: stiff, stained silicone lines and spent valve diaphragms and seals.
Read case →

See all case studies →

Nearby cities

Bunn service in neighboring cities.

More cities

Bunn across our service area.

FAQ

Bunn in Rodeo questions, answered.

Our machine is in Crockett. Is that inside your service area?

Yes. Crockett and Port Costa are covered along with Rodeo. We confirm the service arrangement and price when you book and provide a written quote before repair work.
How do we slow down corrosion on a machine near the water?

Keep the condenser clean, since salt and dust hold moisture against the fins. Leave room around the vents, wipe the cabinet down and have the electrical connections checked once a year. Catching green terminals early is far cheaper than chasing random trips later.
Why does our machine trip the breaker on some days and not others?

An intermittent trip can come from a connection that is loose or corroded, a start part that fails once it is warm, or a circuit shared with other equipment. We test the machine and the outlet under load, trace which one it is, then quote the fix in writing.

Need Bunn service in Rodeo?

Tell us what is broken. We will quote it.