Can the repair happen before our shopping center unit opens?

Often, yes. Seal kits, gear motor work and coil cleaning fit into an early slot, and we plan around your opening time where we can. Sealed-system repairs take longer, and we tell you how long before we start.

The mix-low light is on but the hopper is full. What failed?

Usually the mix-low sensor, not the level. Residue on the sensor or a drifting reading tells the board the hopper is empty. We clean and test the sensor and its wiring. If the sensor reads correctly and the alarm stays, the board is next.

Is it worth fixing a Bunn machine that is more than ten years old?

Usually. Bunn builds these to be serviced, parts support is good, and a gear motor, seal kit or board costs far less than a new dispenser. We suggest replacement only when a dead compressor, a failed board and worn mechanicals all show up at once.

BUNN · PINOLE

Service · All Bunn Models

Bunn Frozen Beverage Machine Repair · Pinole, CA

Bunn frozen and granita dispenser repair in Pinole, from Old Town to the Fitzgerald Drive shopping district.

Bunn equipment connected to the building plumbing is diagnosed on site for $99, credited toward the repair. Countertop units come to our bench; we confirm the bench price when you book.
Same or next-day best effort
CSLB #1136642

Call (925) 999-4095

Bunn in Pinole

Bunn commercial service.

In Pinole, a Bunn Ultra-2 or Ultra-NX might sit in an Old Town storefront, in a building from the turn of the last century, or in a shop near Fitzgerald Drive and the Pinole Vista Shopping Center. Either way, the questions are the same: what failed, what the repair involves, and how to get it done without closing the counter for a day.

Pinole calls go to our technician based in Benicia. We work at the machine, plan the teardown around your hours where we can, and give you a written quote before any part goes in. For Bunn connected to the building plumbing, the on-site diagnostic is $99, credited toward repair. We confirm countertop bench pricing when you book. Anything on the refrigerant side is handled under ADRIUM's EPA 608 Universal certification.

Common repairs we handle.

Ultra-NX display errors and a board that resets. Resets mid-cycle, a frozen display or error codes that clear and come back point at the control side. A loose connector or a failing sensor can mimic a bad board, so we test the sensor inputs and the supply to the board before touching the board itself.
Condenser clogged with dust and grease. A frozen drink machine rejects heat through its condenser, and a coil matted with dust or kitchen grease starves it. Product thins out, the compressor runs hot and start parts fail early. We clean the coil, check the fan and filter, and take pressures to confirm the system recovered.
Auger that stops turning with the motor still running. If the motor runs but the auger sits still, something between them has let go: a worn coupling, stripped gears or a broken part in the drive. We open the drive, find the failed piece and replace it, then run a full freeze cycle before we leave.

Models we service

Bunn product lines.

Ultra-2 and Ultra-NX frozen and granita dispensers
JDF juice and drink units

Pricing and warranty

What it costs. What we stand behind.

Price at booking

Bunn equipment connected to the building plumbing is diagnosed on site for $99, credited toward the repair. Countertop units come to our bench; we confirm the bench price when you book.
Written

Parts and labor, 3 months to 2 years depending on the type of repair. Quoted in writing before work starts.
CSLB

#1136642. Bonded and insured. We file warranty paperwork when applicable.

Recent work

Bunn jobs we have closed.

Union City, CA · Commercial Bean-to-Cup Coffee Machine

Bunn Crescendo Commercial Coffee Machine Repair

A busy Union City location was losing its coffee service. The Crescendo's brew path had worn out: stiff, stained silicone lines and spent valve diaphragms and seals.
Read case →

See all case studies →

Nearby cities

Bunn service in neighboring cities.

More cities

Bunn across our service area.

FAQ

Bunn in Pinole questions, answered.

Can the repair happen before our shopping center unit opens?

Often, yes. Seal kits, gear motor work and coil cleaning fit into an early slot, and we plan around your opening time where we can. Sealed-system repairs take longer, and we tell you how long before we start.
The mix-low light is on but the hopper is full. What failed?

Usually the mix-low sensor, not the level. Residue on the sensor or a drifting reading tells the board the hopper is empty. We clean and test the sensor and its wiring. If the sensor reads correctly and the alarm stays, the board is next.
Is it worth fixing a Bunn machine that is more than ten years old?

Usually. Bunn builds these to be serviced, parts support is good, and a gear motor, seal kit or board costs far less than a new dispenser. We suggest replacement only when a dead compressor, a failed board and worn mechanicals all show up at once.

Need Bunn service in Pinole?

Tell us what is broken. We will quote it.