Skip to main content
ADRIUM Service Solutions
(925) 999-4095 · San Ramon, CA · CSLB #1136642 · BBB A+

COOKING APPLIANCE REPAIR · HILLSBOROUGH

Cooking Appliance Repair · Hillsborough, CA

Built-in pro range and wall oven repair across 94010. Dual-fuel, gas, and induction.

  • $75 diagnostic (waived with repair)
  • Same-day best effort
  • CSLB #1136642
Call (925) 999-4095

Cooking Appliance Repair in Hillsborough

Cooking Appliance Repair in Hillsborough.

Hillsborough sits in one ZIP, 94010, and the kitchens run on built-ins. Wolf and Thermador dual-fuel ranges, Thermador wall ovens, and Bosch and Miele on the cooktops. A lot of these date to early-2000s remodels, so the cooking calls cluster on worn ignition and drifted sensors. The recurring Wolf call is a surface burner that clicks without lighting, traced to a fouled or mispositioned spark electrode, and the Thermador wall ovens come in dead-bake-element or running their temperature off on a tired oven sensor.

The houses sit on grade and the appliance corridors are tight, which matters on a range job. A wide built-in range has to come out of its surround to reach the rear gas and ignition components, and we bring floor protection and take the time to slide it clean rather than rush it past the cabinet. Every call still starts with a meter. We read the gas valve micro-switch before we condemn a spark module, and we verify a sensor before we condemn a board.

What the work looks like

A gas oven burner lighting clean after service.

A gas oven bake burner lighting with an even blue flame after service. The white bar is the glow-bar igniter, and when it weakens the oven will not heat even though it still glows.

Common repairs we do

What we close on the truck.

  • Wolf range, surface burner clicks no light. Fouled or mispositioned spark electrode, or carbon at the tip. We clean, re-gap, and bench-test the valve micro-switch before ordering a module.
  • Thermador wall oven, dead bake element. Single-visit swap with the model number ahead of time. We pull the rear panel, verify resistance, and run a full bake cycle.
  • Pro oven runs temperature off, over-temp fault. Oven temp sensor drifted out of spec. Sensor replacement is quick and the control board is usually fine.
  • Bosch cooktop, induction or gas fault. On induction it is usually a blocked cooling vent. On gas it is usually ignition. We read the symptom and the meter before we order a part.

Pricing and warranty

What it costs. What we stand behind.

  • $75

    Diagnostic visit. Waived when you book the repair with us.

  • 1 yr

    Parts and labor warranty on completed repairs. In writing before we start.

  • CSLB

    #1136642. Bonded and insured. We file warranty paperwork when applicable.

FAQ

Cooking Appliance Repair in Hillsborough questions, answered.

  • How quickly can you reach Hillsborough from San Ramon?
    We block Mid-Peninsula calls on routed days, typically a couple of days a week. Drive from San Ramon is about 45 to 60 minutes when we have a slot. Booked windows get a written arrival time before we leave the shop.
  • Can you pull a wide built-in range without damaging the cabinet?
    Yes. The corridors here are tight and the surrounds are custom, so we bring floor protection and take the time to slide the range out clean. We charge by the visit, not by rushing past the cabinet.
  • My Thermador wall oven will not heat or runs hot. What is it?
    Either a dead bake element or a drifted oven sensor. We meter both before ordering. Give us the model number ahead of the appointment and most of these close in one visit. Diagnostic is $75, waived with the repair.

Need cooking appliance repair in Hillsborough?

Tell us what is broken. We will quote it.

Call (925) 999-4095
Call Now

Schedule a visit

Tell us what you need

  1. 1
  2. 2
  3. 3
  4. 4
What kind of appliance?
Which brand?
What's wrong, or what do you need?
Where can we reach you?

Request received.

Andrew will call you back during business hours to confirm the visit.