How long is the drive to Portola Valley from San Ramon?

Figure 50 to 60 minutes, down 680 south and over on 92 or 280. Portola Valley runs on the same Peninsula day as Hillsborough, so you get a written arrival window rather than a loose morning-or-afternoon guess.

Can you get Dacor parts for a home out toward Alpine Road or Skyline?

Sensors, igniters, and common elements are on the truck already. Control boards and induction generator boards I order in per job, generally a day or two out. Dacor's parts pipeline has been reliable since Samsung took over the brand.

What should I expect to pay for a Dacor igniter or control board repair here?

The diagnostic is $75, waived if you approve the repair. Igniter or element replacement runs $280 to $470, and a control board runs $390 to $620. Any gas work is done under CSLB #1136642, and you get a written quote before I open anything.

DACOR · PORTOLA VALLEY

Service · All Dacor Models

Dacor Cooking Appliance Repair · Portola Valley, CA

Dacor wall oven, dual-fuel range, and induction cooktop repair for Portola Valley homes tucked into the oak and redwood hills.

$75 diagnostic (waived with repair)
Same or next-day best effort
CSLB #1136642

Call (925) 999-4095

Dacor in Portola Valley

Dacor in Portola Valley kitchens.

Off Alpine Road and Portola Road, the custom homes on wooded acreage often built a Dacor wall oven into the kitchen plan, and in the Ladera-adjacent pockets I still find Dacor cooking units original to the mid-century modern houses, paired since with a newer range or cooktop from someone else. Toward Skyline, the ranch properties tend to run a single Dacor bank rather than the double-oven stacks I see closer to town.

The failure pattern does not care about the house style. At year eight and beyond it is almost always a stored fault code that has taken out the display, or a bake temperature that has wandered off the set point because the sensor lost calibration. ZIP 94028. Drive time from San Ramon runs 50 to 60 minutes on 680 south and then 92 or 280, and Portola Valley gets scheduled on the same Peninsula day as Hillsborough with a written arrival window.

Water and ice systems

The water inlet valve, a common fridge leak.

Every fridge with a dispenser or ice maker has a water inlet valve. The fittings can leak under the cabinet, or the solenoid fails and the dispenser and ice maker stop getting water.

Common repairs we do

What we close on the truck.

Stored fault code kills the oven display. The ERC control board latches a fault and the display goes blank or the oven stops responding. I read the code, test the board, and replace it only when the board itself is the failure.
Oven runs hot or cold against the dial. Temperature sensor drift is the usual cause once a unit passes year eight. I verify the sensor reading against the dial setting and recalibrate before considering a board swap.
Weak igniter, slow or skipped ignition. The bake or broil igniter loses output with age and the burner takes longer to catch, or misses entirely. Replacing the igniter or the element resolves it.
Induction element fault, or a door that will not seal. On induction units an element fault code traces to the generator board. On the ovens, a door that no longer closes flush usually means the hinge and the gasket have both worn and need replacing at the same time.

Models we service

Dacor product lines.

Wall ovens (Heritage, Discovery, Renaissance, Distinctive)
Dual-fuel, gas, and pro ranges (HDER, HDPR, HIPR)
Renaissance induction ranges (RR30)
Cooktops and rangetops
Built-in and freestanding refrigeration
Dishwashers

Pricing and warranty

What it costs. What we stand behind.

$75

Diagnostic visit. Waived when you book the repair with us.
Written

90 days on consumables, 1 year on major parts, 2 years on sealed-system rebuilds. Quoted in writing before work starts.
CSLB

#1136642. Bonded and insured. We file warranty paperwork when applicable.

Nearby cities

Dacor service in neighboring cities.

FAQ

Dacor in Portola Valley questions, answered.

How long is the drive to Portola Valley from San Ramon?

Figure 50 to 60 minutes, down 680 south and over on 92 or 280. Portola Valley runs on the same Peninsula day as Hillsborough, so you get a written arrival window rather than a loose morning-or-afternoon guess.
Can you get Dacor parts for a home out toward Alpine Road or Skyline?

Sensors, igniters, and common elements are on the truck already. Control boards and induction generator boards I order in per job, generally a day or two out. Dacor's parts pipeline has been reliable since Samsung took over the brand.
What should I expect to pay for a Dacor igniter or control board repair here?

The diagnostic is $75, waived if you approve the repair. Igniter or element replacement runs $280 to $470, and a control board runs $390 to $620. Any gas work is done under CSLB #1136642, and you get a written quote before I open anything.

Need Dacor service in Portola Valley?

Tell us what is broken. We will quote it.