How fast can you reach Piedmont from San Ramon?

We route Inner-East-Bay calls on planned days. Drive is 35 to 45 minutes via 24 and 580, so Piedmont is a regular stop most weeks. Booked windows get a written arrival time before we leave.

My condensing dryer takes two cycles to dry. Is it dead?

Usually not. On Bosch and Miele condensing units in Piedmont it is almost always a fouled condenser and a restricted vent run through the finished walls. We clean the condenser, verify cycle time against spec, and check the duct.

The washer dances across the floor on spin. What is that?

Front-loads here lose shock absorbers and spider-arm balance over time. We watch the spin, check the suspension and the counterweight bolts, and replace what is actually worn rather than guessing.

LAUNDRY REPAIR · PIEDMONT

Laundry Repair · Piedmont, CA

Washer and dryer repair for Piedmont hill houses. Front-load, stacked, condensing.

$75 diagnostic (waived with repair)
Same or next-day best effort
CSLB #1136642

Call (925) 999-4095

Laundry Repair in Piedmont

Laundry Repair in Piedmont.

Piedmont kitchens lean Sub-Zero and Wolf, but the laundry rooms tell a different story. Across 94610 and 94611 the hill-house remodels mostly put in front-load LG and Electrolux pairs, with Miele and Bosch condensing units in the higher-end builds where there is no proper dryer vent run. The older central-Piedmont homes still run GE and Whirlpool top-loads from earlier remodel cycles. What we see again and again on these hill lots is a long, kinked dryer vent buried in finished walls, which is what kills airflow and bakes the heating element.

We diagnose before we open anything. Read the fault code, watch the spin balance, meter the door and lid switch. A growling drum under spin load is a bearing, and on these front-loads it usually shows up at the 8 to 10 year mark. Condensing and heat-pump dryers in the panel-ready installs almost always come down to a clogged condenser, not a dead machine.

Common repairs we do

What we close on the truck.

LG front-load LE motor fault. Rotor-position sensor drifted out of spec. Single-visit sensor swap. Do not let anyone sell you a new motor for this.
Electrolux Perfect Steam torn door boot. Common on the front-loads up here. OEM boot, 45-minute job. A torn boot leaks onto the floor, so we fix it on the visit.
Bosch condensing dryer will not heat. Element or high-limit thermostat. We meter both before ordering parts so you pay for the one that failed.
Vented dryer drum bearing growl. Rear bearing worn on the older GE and Whirlpool units. We replace the rear bearing, front felt seal, idler pulley, and belt together so it is not a callback.

Pricing and warranty

What it costs. What we stand behind.

$75

Diagnostic visit. Waived when you book the repair with us.
1 yr

Parts and labor warranty on completed repairs. In writing before we start.
CSLB

#1136642. Bonded and insured. We file warranty paperwork when applicable.

Nearby cities

Laundry Repair in neighboring cities.

More cities

Laundry Repair across our service area.

FAQ

Laundry Repair in Piedmont questions, answered.

How fast can you reach Piedmont from San Ramon?

We route Inner-East-Bay calls on planned days. Drive is 35 to 45 minutes via 24 and 580, so Piedmont is a regular stop most weeks. Booked windows get a written arrival time before we leave.
My condensing dryer takes two cycles to dry. Is it dead?

Usually not. On Bosch and Miele condensing units in Piedmont it is almost always a fouled condenser and a restricted vent run through the finished walls. We clean the condenser, verify cycle time against spec, and check the duct.
The washer dances across the floor on spin. What is that?

Front-loads here lose shock absorbers and spider-arm balance over time. We watch the spin, check the suspension and the counterweight bolts, and replace what is actually worn rather than guessing.

Need laundry repair in Piedmont?

Tell us what is broken. We will quote it.