Do you cover Dublin from San Ramon?

Yes. Dublin sits right next to San Ramon, and it is one of our closest service areas. We come across on I-680 and it is usually about a ten to twelve minute drive, which also makes Pleasanton an easy stop on the same trip.

My Breville is only two or three years old. Is it worth fixing?

Usually yes. On a machine that young the failure is almost always a single part, a thermostat, a sensor, a valve, rather than the whole machine wearing out. That is a good repair to make. We confirm the exact fault at the $75 diagnostic and put the repair in a written quote, so you can decide with real numbers in front of you.

Are you a Breville authorized repair center?

No. We are an independent appliance repair shop, EPA 608 certified and CSLB licensed number 1136642, but not authorized or certified by Breville. We fix Breville machines that are out of warranty. If yours is still inside the Breville warranty, run that first, since only they can honor it.

BREVILLE · DUBLIN

Service · All Breville Models

Breville Espresso Machine Repair · Dublin, CA

Breville espresso repair in Dublin, from Dublin Ranch out to Schaefer Ranch.

$75 diagnostic (waived with repair)
Same or next-day best effort
CSLB #1136642

Call (925) 999-4095

Breville in Dublin

Breville in Dublin kitchens.

Dublin is mostly newer construction, from the homes in Dublin Ranch and Tassajara Hills to the hillside builds up in Schaefer Ranch. A lot of those kitchens came with room for a real espresso setup, and the Breville Barista Pro, Barista Express, and Bambino Plus are the machines I work on most here.

The fault I get called for most in Dublin is a machine that will not reach brew temperature, or that throws a heating error and quits. On a Breville that points at the ThermoJet heater, its thermostat, or the temperature sensor. Because so many Dublin machines are only a few years old, it is often a single sensor or thermostat rather than a worn-out boiler, and I test the circuit before quoting so you only pay for the part that failed.

Built-in and premium Brevilles are less common in the newer tract homes near Fallon and Emerald Glen than up in the Schaefer Ranch and Tassajara Hills builds, but we service both. A Bambino in a first apartment and a Dual Boiler on a hillside island get the same bench test, the same honest read, and the same written quote before any part goes in.

Common repairs we do

What we close on the truck.

Barista Pro throws a heating fault and will not warm up. When a Barista Pro or Barista Express fails to reach temperature or flashes a heating error, the ThermoJet heater, its thermostat, or the temperature sensor is usually the cause. We test the heating circuit from the sensor through the element, compare the readings the machine is acting on against reality, and check for scale that is making the coil run inefficient. We confirm the machine heats and holds temperature through a full brew before we sign off.
Pump is loud and pressure is weak. A Breville that suddenly gets loud and pulls thin shots often has a struggling vibratory pump or an over-pressure valve leaking by. We put a gauge on it, read the actual pressure, and separate a failing pump from a valve issue or a blockage in the water path. On the newer Dublin machines it is often just a stuck or scaled OPV rather than a dead pump, and I will show you which it is before quoting the part.
Grinder clumps and doses inconsistently on the Bambino setup. For Bambino owners grinding on a Breville Smart Grinder, or Barista owners using the built-in burrs, inconsistent dosing usually comes from caked grounds in the chute or worn burrs. You get clumps, a light basket, and a shot that runs too fast. We clean the grind path, inspect and align the burrs, and reset the dose. If the burrs are worn we quote a replacement set instead of leaving you fighting the grind adjustment.

Models we service

Breville product lines.

Barista Pro (BES878), Barista Express, Barista Touch
Bambino and Bambino Plus
Oracle and Oracle Touch
Dual Boiler (BES920)

Pricing and warranty

What it costs. What we stand behind.

$75

Diagnostic visit. Waived when you book the repair with us.
Written

90 days on consumables, 1 year on major parts, 2 years on sealed-system rebuilds. Quoted in writing before work starts.
CSLB

#1136642. Bonded and insured. We file warranty paperwork when applicable.

Recent work

Breville jobs we have closed.

Concord, CA · Breville Barista Pro espresso machine

Breville Barista Pro Only Ran 5 Seconds in Concord: A Loose Thermostat, No Parts

A Breville Barista Pro brought in from Concord would power on but only run for about five seconds before shutting off, so it could never pull a shot.
Read case →

See all case studies →

Nearby cities

Breville service in neighboring cities.

FAQ

Breville in Dublin questions, answered.

Do you cover Dublin from San Ramon?

Yes. Dublin sits right next to San Ramon, and it is one of our closest service areas. We come across on I-680 and it is usually about a ten to twelve minute drive, which also makes Pleasanton an easy stop on the same trip.
My Breville is only two or three years old. Is it worth fixing?

Usually yes. On a machine that young the failure is almost always a single part, a thermostat, a sensor, a valve, rather than the whole machine wearing out. That is a good repair to make. We confirm the exact fault at the $75 diagnostic and put the repair in a written quote, so you can decide with real numbers in front of you.
Are you a Breville authorized repair center?

No. We are an independent appliance repair shop, EPA 608 certified and CSLB licensed number 1136642, but not authorized or certified by Breville. We fix Breville machines that are out of warranty. If yours is still inside the Breville warranty, run that first, since only they can honor it.

Need Breville service in Dublin?

Tell us what is broken. We will quote it.

Call (925) 999-4095