Bosch Repair · Bay Area

ADRIUM repairs Bosch French-door and built-in refrigerators, induction cooktops, and wall ovens across 65 Bay Area cities, with a $99 diagnostic credited toward the repair.

Bosch’s dishwasher lineup, the 800 Series and Benchmark units built around the same recirc pump and drain pump as the 500 Series, is where a lot of the brand’s reputation comes from. We service them too, with the repair price confirmed after diagnosis.

We diagnose and repair Bosch dishwashers. Repairs can be expensive; the $99 diagnostic, credited toward the repair, gives you a written price before you decide. On Bosch, the heating element is built into the circulation pump, so a heating fault usually means a new pump.

Bosch 800 Series French-door refrigerators have an evaporator-fan icing issue in the freezer compartment. The defrost-cycle heater runs but the drain line freezes shut, water pools, and freezes the evap fan into the back wall. Symptom is loud fan rattle for a week, then warming fresh-food side. We diagnose the fault on site, then provide a written repair estimate and timeline.

The built-in side-by-side units are a different animal. They run an inverter compressor and a magnetic solenoid valve that diverts refrigerant between the fresh-food and freezer coils, so a one-sided cooling problem is often that valve or its control, not the compressor. We check the valve and read the NTC sensors before opening the sealed system. The other Bosch side-by-side call is the motorized glass shelf, which vibrates, runs noisy, or stops moving. Bosch revised the slider and shelf mechanism across several production dates, so the fix depends on the build date and we match the updated part rather than reinstalling the old one. The temperature-controlled drawer and its NTC sensor are the third common call. This whole refrigeration lineup sells well above our $1,000 threshold for a mainstream repair to make sense, which is why we take these calls without hesitation. Sealed-system work is quoted in writing after an on-site diagnosis.

Induction cooktops throw an F47 or E5 code for IGBT power-module overheating. Usually it is a blocked cooling-fan vent under the cooktop, not a board failure. We pull the unit, vacuum the fan intake and the heat sink, and verify the IGBT temperature with a thermal probe before condemning an expensive board over a dust problem.

Wall ovens use the same European-style hidden bake element. When it fails, no glow from the bottom and the oven cycles cold. Element replacement is scheduled after the on-site diagnosis if we get the model number from you ahead of the appointment. We diagnose Bosch wall ovens for $99, credited toward the repair, and quote before any work.

Furnace or AC also on your mind? That’s our Bay Area HVAC Service division, and the assessment visit is free if you’re facing a system replacement.

A Water Inlet Valve, On Camera

Load video

A Gas Oven Burner and Igniter, On Camera

Load video