TEMPSTAR · BURLINGAME
Service · All Tempstar ModelsTempstar Heat Pump, AC & Furnace Repair · Burlingame, CA
Tempstar furnace and heat pump repair in Burlingame, using Carrier-family parts.
- $99 diagnostic (credited toward the repair)
- Same or next-day best effort
- CSLB #1136642
Tempstar in Burlingame
Tempstar heating and cooling in Burlingame.
Tempstar is ICP hardware, the same platform Carrier builds under the Heil and Comfortmaker names, wearing a value badge. That is good news for Burlingame homeowners because the parts are common and inexpensive. A Tempstar in an older Burlingame house is usually a closet or attic furnace pushing air through original ducting, and the failures track that hard duty.
Burlingame's marine layer keeps furnaces working most of the year, mornings especially, so ignition components and inducer motors here rack up cycles faster than inland units. The heat pumps we see are newer, often installed during condo renovations, and their issues lean toward defrost controls and sensor faults rather than mechanical wear.
We diagnose for $99, credit it toward the repair, and put the quote in writing before touching a part. If you ever replace the system, our installs carry ten years parts, labor two years standard (ten years on our maintenance plan).
Burlingame details
Tempstar service in Burlingame: the local facts.
Burlingame is about 25 miles from our base in San Ramon, in a straight line. We service ZIP codes 94010 and 94011 in Burlingame.
Across the Bay Area we completed more than 1,200 repair and service jobs in the last 12 months.
Tempstar product lines and all 65 cities we cover for the brand are on our Tempstar page.
Common repairs we handle.
- Hot surface ignitor failure. The classic Tempstar no-heat call. The furnace clicks through its sequence, the inducer runs, and then nothing lights. The silicon carbide ignitor cracks from thermal cycling, and Burlingame's constant morning heat calls accelerate it. I replace it with the upgraded silicon nitride version so it does not become an annual event.
- Flame sensor dropout, burner lights then dies. Burners fire for three seconds and shut down, three tries and the board locks out. Oxide film on the flame sensor blocks the microamp signal. I clean or replace the sensor, verify the signal with a meter, and inspect the burners for the rust flaking that often rides along in coastal-air furnaces.
- Inducer motor bearing wear. A whine or grind before the burners light means the draft inducer bearings are going. Tempstar shares the ICP inducer assemblies with Heil and Comfortmaker, so the part is easy to get. I also check the pressure switch and condensate path, because a failing inducer sometimes masks a drain problem.
Pricing and warranty
What it costs. What we stand behind.
-
$99
Diagnostic visit. Credited toward the repair.
-
Written
1-year warranty on repairs. Quoted in writing before work starts.
-
CSLB
#1136642. Bonded and insured. We file warranty paperwork when applicable.
Nearby cities
Tempstar service in neighboring cities.
FAQ
Tempstar in Burlingame questions, answered.
-
How do you schedule a no-heat call in Burlingame?
Yes. Our Peninsula technician is based in San Mateo and covers Burlingame. We run Burlingame with our Hillsborough route. No-heat calls jump the queue, and Tempstar shares parts with the whole ICP family. We provide a written repair estimate after the on-site diagnosis and before any work starts. -
Is Tempstar a cheap brand I should replace with something better?
No. It is Carrier engineering with less marketing money. A Tempstar with a failed ignitor or inducer is a repair, not a replacement conversation. When a heat exchanger or compressor goes on an old unit, I will show you the numbers both ways and you decide. Rebates change constantly, so we confirm what is actually paying at estimate time. -
My condo heat pump keeps icing up. Is that normal?
Light frost that clears in a defrost cycle is normal in Burlingame's damp mornings. A solid ice shell is not. That points to a defrost board, a stuck reversing valve, or low charge. I am EPA 608 certified, so if it is charge, I find the leak and fix it rather than topping it off blind.
Need Tempstar service in Burlingame?