HOSHIZAKI · SAN BRUNO
Service · All Hoshizaki ModelsHoshizaki Ice & Refrigeration Service · San Bruno, CA
Hoshizaki ice and refrigeration service for San Bruno's Tanforan corridor and San Bruno Avenue kitchens, where the Gap wind loads up condenser fins.
- $99 diagnostic (waived with repair)
- Same or next-day best effort
- CSLB #1136642
Hoshizaki in San Bruno
Hoshizaki commercial service.
San Bruno work centers on the San Bruno Avenue restaurant strip, the food court at the Shops at Tanforan, and the corporate cafeterias that came in with the tech offices near the old racetrack site. Most of the kitchens here are small footprint, so I'm servicing undercounter cubers and compact reach-ins more than the big banquet-hall machines I'd see a few miles north.
San Bruno sits in the wind gap that funnels marine air across the Peninsula, and that wind carries fine grit and pollen that packs into condenser fins harder than the still fog you get closer to the coast. It's a different fouling mechanism than the damp buildup I clean off machines in Daly City, more abrasive dust than sticky film, but the result is the same high head pressure trip if the coil goes too long unattended.
ADRIUM Service Solutions runs out of San Ramon, CSLB #1136642, EPA 608 certified. Diagnostic is $99, waived when you book the repair, written quote before I touch anything. We work the Peninsula seven days a week.
Common repairs we do
What we close on the truck.
- Condenser coil clogging from Gap wind grit. The wind funneling through San Bruno packs dust and fine debris into the fins faster than a typical Peninsula location. Head pressure climbs and the compressor starts short-cycling on hot afternoons. I comb the fins clean, check the fan motor amperage, and set a shorter cleaning interval for units mounted near an alley or a loading area exposed to the wind.
- Evaporator fan motor failure in tight reach-ins. Small kitchen footprints along San Bruno Avenue mean reach-ins get shoved close to a wall or another piece of equipment, and the evaporator fan motor runs hotter than it should with restricted airflow. The motor burns out early and the box drifts warm. I check clearance first, then test and replace the motor if it's already past saving.
- Hot gas valve hang on KM cubers. Same failure I see across the Peninsula on aging KM series units. Cubes hang on the plate, the harvest cycle stretches or aborts, and production falls off. I isolate the valve, test the coil against resistance spec, and replace with an OEM part. This is not a job for an aftermarket coil.
Models we service
Hoshizaki product lines.
- KM cuber ice machines
- Refrigerated prep tables
- Sushi display cases
- Ice and water dispensers
- Undercounter ice
Pricing and warranty
What it costs. What we stand behind.
-
$99
Diagnostic visit. Waived when you book the repair with us.
-
Written
3 months standard, 1 year on inverter boards, up to 2 years on sealed-system rebuilds. Quoted in writing before work starts.
-
CSLB
#1136642. Bonded and insured. We file warranty paperwork when applicable.
Nearby cities
Hoshizaki service in neighboring cities.
More cities
Hoshizaki across our service area.
- Hoshizaki in Alamo
- Hoshizaki in Berkeley
- Hoshizaki in Blackhawk
- Hoshizaki in Concord
- Hoshizaki in Danville
- Hoshizaki in Dublin
- Hoshizaki in Hayward
- Hoshizaki in Lafayette
- Hoshizaki in Livermore
- Hoshizaki in Milpitas
- Hoshizaki in Oakland
- Hoshizaki in Palo Alto
- Hoshizaki in Pleasanton
- Hoshizaki in San Leandro
- Hoshizaki in San Ramon
- Hoshizaki in Santa Clara
- Hoshizaki in Walnut Creek
- Hoshizaki in Alameda
- Hoshizaki in Atherton
- Hoshizaki in Castro Valley
- Hoshizaki in Cupertino
- Hoshizaki in Fremont
- Hoshizaki in Hillsborough
- Hoshizaki in Los Altos Hills
- Hoshizaki in Los Altos
- Hoshizaki in Los Gatos
- Hoshizaki in Martinez
- Hoshizaki in Menlo Park
- Hoshizaki in Moraga
- Hoshizaki in Mountain View
- Hoshizaki in Newark
- Hoshizaki in Orinda
- Hoshizaki in Piedmont
- Hoshizaki in Pleasant Hill
- Hoshizaki in Richmond
- Hoshizaki in San Jose
- Hoshizaki in Saratoga
- Hoshizaki in Sunnyvale
- Hoshizaki in Union City
- Hoshizaki in Burlingame
- Hoshizaki in Albany
- Hoshizaki in El Cerrito
- Hoshizaki in Woodside
- Hoshizaki in Portola Valley
- Hoshizaki in Belmont
- Hoshizaki in San Carlos
- Hoshizaki in Redwood City
- Hoshizaki in East Palo Alto
- Hoshizaki in Half Moon Bay
- Hoshizaki in Daly City
- Hoshizaki in San Mateo
- Hoshizaki in Foster City
FAQ
Hoshizaki in San Bruno questions, answered.
-
How fast can you actually get to San Bruno for a down machine?
We have a technician based in San Mateo County, so San Bruno is a short local trip now, not a haul from the East Bay. I won't promise you a specific hour over the phone, but you're not waiting on a truck crossing the bay to reach you. -
Do you stock parts for the small undercounter units common in San Bruno kitchens?
Yes. Compact KM undercounter parts, evaporator fan motors, hot gas valves, and calibrated thermistors ride on the truck. If your unit is an older model that's been discontinued, I'll tell you straight whether the part needs to be sourced before I quote a timeline. -
What's the cost to get a technician out to look at the machine?
The diagnostic is $99 and it's waived if you approve the repair. I give you the number in writing after I've actually opened the unit, not a guess based on what you describe over the phone.
Need Hoshizaki service in San Bruno?