FISHER & PAYKEL · MILLBRAE
Service · All Fisher & Paykel ModelsFisher & Paykel Built-in Appliance Repair · Millbrae, CA
Fisher & Paykel DishDrawer repair in Millbrae, by a tech who actually stocks the lid actuator
- $99 diagnostic (credited toward the repair)
- Same or next-day best effort
- CSLB #1136642
Fisher & Paykel in Millbrae
Fisher & Paykel in Millbrae kitchens.
Fisher & Paykel shows up in Millbrae in two places: kitchen remodels in the mid-century homes off Magnolia and Taylor where the owner wanted a double DishDrawer instead of a standard tub, and the newer condos near the BART and Caltrain hub where a single DishDrawer fits a compact kitchen. Both configurations fail in the same predictable ways, and I have serviced enough of them to know the sequence before I open the panel.
The DishDrawer is the brand's signature unit and it has signature failure modes. The lid actuator on a double DishDrawer wears out around year five. The symptom is always the same: the drawer will not lock, a lid fault flashes, and the cycle refuses to start. Owners often assume the control board died. Usually it did not. The actuator motor that seals the lid against the tub has simply worn its gear train, and it is a repairable part, not a reason to replace the machine.
We run Fisher & Paykel calls in Millbrae on a $99 diagnostic that gets credited toward the repair, with a written quote before any part goes in and a 90-day warranty on the work (one year on inverter boards).
Millbrae details
Work we documented in Millbrae.
Millbrae is about 26 miles from our base in San Ramon, in a straight line. We service ZIP code 94030 in Millbrae.
Across the Bay Area we completed more than 1,200 repair and service jobs in the last 12 months.
Fisher & Paykel product lines and all 65 cities we cover for the brand are on our Fisher & Paykel page. Recent published jobs from Millbrae are on our Millbrae page.
Published jobs near Millbrae
Common repairs we handle.
- Lid actuator replacement on double DishDrawers. Around year five the lid actuator gear train wears out, the drawer cannot pull the lid down to seal, and the machine flashes a lid fault and aborts the cycle. I replace the actuator assembly rather than forcing the old one, because a partially sealing lid also causes slow leaks into the base pan.
- Rotor and motor controller faults. The DishDrawer uses a single brushless rotor for wash and drain. When the controller loses rotor position the drawer hums, stops mid-cycle, or throws motor faults. I test the stator windings and the controller separately, since swapping both when only one failed doubles the parts bill for nothing.
- Flood switch trips from tub and hose seepage. Water reaching the base pan trips the flood sensor and locks the unit out. On Millbrae units I most often trace it to a hardened tub-to-lid seal or a weeping drain hose connection. Drying the pan without fixing the seep just schedules the next lockout for two weeks later.
Pricing and warranty
What it costs. What we stand behind.
-
$99
Diagnostic visit. Credited toward the repair.
-
Written
Parts and labor, 3 months to 2 years depending on the type of repair. Quoted in writing before work starts.
-
CSLB
#1136642. Bonded and insured. We file warranty paperwork when applicable.
Nearby cities
Fisher & Paykel service in neighboring cities.
FAQ
Fisher & Paykel in Millbrae questions, answered.
-
How fast can you get from San Ramon to a DishDrawer call in Millbrae?
We are based in San Ramon, so the run is over the San Mateo Bridge and up 101, usually 50 to 60 minutes outside commute peaks. We route Millbrae together with Hillsborough, where we see a lot of Fisher & Paykel in the larger kitchens, so same-day or next-day slots on the Peninsula are normal, 7 days a week. -
Is a five year old DishDrawer worth fixing, or should I replace it?
Usually worth fixing. The lid actuator, seals, and rotor are all serviceable parts, and a repaired DishDrawer commonly runs another five plus years. I give you the written quote after the $99 diagnostic, the fee is credited toward the repair, and you decide with real numbers instead of guesses. -
Do you work on Fisher & Paykel refrigeration too, or only DishDrawers?
Both. We service ActiveSmart refrigerators and integrated columns as well. I am EPA Section 608 Universal certified, so sealed-system diagnosis on the refrigeration side is done in-house, not subcontracted out.
Need Fisher & Paykel service in Millbrae?