Skip to main content
ADRIUM Service Solutions
(925) 999-4095 · San Ramon, CA · CSLB #1136642 · BBB A+
Call

WILLIAMS · DALY CITY

Service · All Williams Models

Williams Wall Furnace & Heating Repair · Daly City, CA

Williams wall furnace repair in Daly City, keeping the Doelger-built Westlake homes warm through the fog.

  • $99 diagnostic (waived with repair)
  • Same or next-day best effort
  • CSLB #1136642
Call (925) 999-4095

Williams in Daly City

Williams in Daly City kitchens.

Daly City sits right on the fog line, and the thousands of nearly identical Doelger-built homes in Westlake and around Serramonte from the 1950s often still run their original Williams wall furnace tucked in a hallway closet.

The marine layer sits over Daly City more days than not, and that damp air works into the pilot assembly and burner over the decades, so no-heat calls here usually trace back to moisture and age rather than hard use.

ADRIUM handles this through Bay Area HVAC Service out of San Ramon, and we also cover neighboring Brisbane on the same trip. We're CSLB licensed and EPA 608 certified, the $99 diagnostic comes off your bill once you book the repair, and you get a written quote before any work starts, every day of the week.

Common repairs we do

What we close on the truck.

  • Thermocouple giving out from fog and damp. The marine layer that sits over Daly City most mornings gets into the pilot area over the years and speeds up thermocouple wear. The pilot holds but the main burner drops out after a few minutes. I test millivolt output and swap the thermocouple.
  • Original Doelger-home unit past its working life. Plenty of Westlake and Serramonte homes still have the Williams wall furnace installed when the tract was built in the 1950s. When I find rust through the burner box or a cracked heat exchanger, I shut it down and write a quote for replacement instead of patching an unsafe unit.
  • Clogged pilot orifice from years of light fog-belt use. Because Daly City stays cool most of the year, these furnaces cycle on low and off again rather than running hard, and that leaves carbon in the pilot orifice. I clean the orifice and confirm a steady flame before I leave.

Models we service

Williams product lines.

  • Wall furnaces (Williams Cozy and Direct-Vent)
  • Gravity and forced-air floor furnaces
  • Pilot and electronic ignition systems
  • Thermocouples, thermopiles, and gas valves
  • Console and high-efficiency direct-vent heaters

Pricing and warranty

What it costs. What we stand behind.

  • $99

    Diagnostic visit. Waived when you book the repair with us.

  • Written

    3 months standard, 1 year on inverter boards, up to 2 years on sealed-system rebuilds. Quoted in writing before work starts.

  • CSLB

    #1136642. Bonded and insured. We file warranty paperwork when applicable.

Nearby cities

Williams service in neighboring cities.

FAQ

Williams in Daly City questions, answered.

  • Do you cover Brisbane too
    Yes. Brisbane sits right against Daly City and we take calls there on the same runs, along with South San Francisco and San Bruno.
  • How fast can someone get to Daly City
    We have a technician based on the Peninsula in San Mateo County, so Daly City is a shorter drive for us than it would be from San Ramon. We don't promise same-day, but we'll give you an honest arrival window when you call.
  • Is the $99 diagnostic fee waived if I book the repair
    Yes. You pay the $99 to have us diagnose the furnace, and if you go ahead with the repair we quoted, that fee comes off the bill.

Need Williams service in Daly City?

Tell us what is broken. We will quote it.

Call (925) 999-4095
Call Now

Schedule a visit

Tell us what you need

  1. 1
  2. 2
  3. 3
  4. 4
What kind of appliance?
Which brand?
What's wrong, or what do you need?
Where can we reach you?

Request received.

Andrew will call you back during business hours to confirm the visit.