Do you carry the parts for the Hoshizaki units typically running in El Cerrito?

Truck stock covers KM cuber hot-gas valves, water-pump assemblies, calibrated thermistors, undercounter gasket kits, and descale chemistry. Coils on the hot-gas valves are OEM only, aftermarket doesn't hold up.

What does a Hoshizaki descale or repair call typically run in El Cerrito?

Diagnostic is $99 and comes off the bill once you book the repair. A KM cuber descale lands between $280 and $440 depending on how much scale has built up. A hot-gas valve swap runs $380 to $560 parts and labor. You get a written quote before any of it starts.

HOSHIZAKI · EL CERRITO

Service · All Hoshizaki Models

Hoshizaki Ice & Refrigeration Service · El Cerrito, CA

Hoshizaki ice and refrigeration service for El Cerrito restaurants, bakeries, and the El Cerrito Plaza food tenants.

$99 diagnostic (waived with repair)
Same or next-day best effort
CSLB #1136642

Call (925) 999-4095

Hoshizaki in El Cerrito

Hoshizaki commercial service.

El Cerrito's commercial work runs along the San Pablo Avenue strip and inside El Cerrito Plaza. Smaller kitchens than the bigger Berkeley corridors, so it's mostly undercounter cubers and reach-in prep units at the bakeries and delis, with a handful of full KM-series cubers at the sit-down restaurants near the Plaza. Ice out on a Friday night closes the bar rail fast.

The calibrated thermistor and the common gasket kits stay stocked on the truck year round. Drive time from San Ramon is 40 to 45 minutes via 580 or 24 to 80, and we route El Cerrito with our Berkeley and Richmond Inner East Bay days. After-hours: (925) 999-4095.

Common repairs we do

What we close on the truck.

Coil block sets off the undercounter high-temp alarm. The most common call on the smaller reach-ins at San Pablo Avenue bakeries and delis. We clean the coil, check the fan motor, and swap the filter.
KM-series cuber loses production to scale. Ice comes out cloudy or thin and production drops. We delime and verify output, then set a recurring schedule so it doesn't happen again mid-rush.
Hot-gas valve sticks open on KM cubers. We isolate the valve and test coil resistance before replacing with OEM parts only. Aftermarket coils fail early and end up costing more.
Water-pump bearing wears out around year seven. Once the bearing goes we swap the entire pump assembly rather than just the motor.

Models we service

Hoshizaki product lines.

KM cuber ice machines
Refrigerated prep tables
Sushi display cases
Ice and water dispensers
Undercounter ice

Pricing and warranty

What it costs. What we stand behind.

$99

Diagnostic visit. Waived when you book the repair with us.
Written

3 months standard, 1 year on inverter boards, up to 2 years on sealed-system rebuilds. Quoted in writing before work starts.
CSLB

#1136642. Bonded and insured. We file warranty paperwork when applicable.

Nearby cities

Hoshizaki service in neighboring cities.

More cities

Hoshizaki across our service area.

FAQ

Hoshizaki in El Cerrito questions, answered.

How quickly can you reach El Cerrito for a Hoshizaki service call?

Drive time from San Ramon is 40 to 45 minutes via 580 or 24 to 80. We route El Cerrito with our Berkeley and Richmond Inner East Bay days, and booked windows get a written arrival time.
Do you carry the parts for the Hoshizaki units typically running in El Cerrito?

Truck stock covers KM cuber hot-gas valves, water-pump assemblies, calibrated thermistors, undercounter gasket kits, and descale chemistry. Coils on the hot-gas valves are OEM only, aftermarket doesn't hold up.
What does a Hoshizaki descale or repair call typically run in El Cerrito?

Diagnostic is $99 and comes off the bill once you book the repair. A KM cuber descale lands between $280 and $440 depending on how much scale has built up. A hot-gas valve swap runs $380 to $560 parts and labor. You get a written quote before any of it starts.

Need Hoshizaki service in El Cerrito?

Tell us what is broken. We will quote it.