How fast can you get to Alameda from San Ramon?

Drive time is 35 to 50 minutes via 580 and the Webster Tube. We pair Alameda with our Oakland route, so island calls land on routed days. Booked windows get a written arrival time before we leave the shop.

My Electrolux front-load washer leaks from the door. Is it the boot?

Usually, yes. The Perfect Steam boot tears low on the seal and weeps during the wash. We carry the OEM boot in both 27-inch sizes and replace it on the first visit. We check the drain pump and the outer-tub seal before condemning the boot, since a slow drain looks like a leak.

Why does my heat-pump dryer take forever to dry?

Almost always the condenser fins are packed with lint. Heat-pump models need those fins cleaned about every twelve months. We clean and test the cycle. If the heat pump itself is faulty we tell you straight, but nine times out of ten it is just the fins.

ELECTROLUX · ALAMEDA

Service · All Electrolux Models

Electrolux Laundry, Refrigeration, and Cooking Repair · Alameda, CA

Electrolux laundry, fridge, and range repair across Alameda. 94501 and 94502.

$75 diagnostic (waived with repair)
Same or next-day best effort
CSLB #1136642

Call (925) 999-4095

Electrolux in Alameda

Electrolux in Alameda kitchens.

Electrolux is mainstream stock in Alameda, the kind that runs the houses off Park Street, Webster, and South Shore. These are mid-century and Victorian places where the kitchen and the laundry got remodeled one at a time, so the Electrolux you find is usually a Perfect Steam front-load pair in a back-porch closet or a garage stack. The 94501 island calls run heavy on laundry. A torn door boot and a grinding drain pump are the two that fill the route.

The front-load boot fails low on the seal from coins and hairpins, common in a family island house with a lot of pockets going through the wash. Drain pumps grind when something hard gets past the trap. On Bay Farm in 94502, the newer townhome stacks add those same two failures plus a heat-pump dryer that quits drying. People there think the dryer died. The condenser fins are packed with lint, and once they clog the dryer can't move heat.

Water and ice systems

The water inlet valve, a common fridge leak.

Every fridge with a dispenser or ice maker has a water inlet valve. The fittings can leak under the cabinet, or the solenoid fails and the dispenser and ice maker stop getting water.

Common repairs we do

What we close on the truck.

Perfect Steam door boot replacement. OEM boot, both 27-inch front-load sizes carried on the truck. Boot tears low on the seal from coins and underwire. About a 45-minute job done right.
Front-load drain pump service. Pull the pump, clear the impeller of trapped objects, replace the unit if the bearing is shot and grinding.
Heat-pump dryer condenser cleaning. Bay Farm stacks. Fins pack with lint and the dryer stops drying. Clean the condenser and run a test cycle.
French-door ice-maker assembly. Cracked ice mold, iced fill tube, seized motor. Whole-assembly swap, kit carried for the common Electrolux French-door models.

Models we service

Electrolux product lines.

French door refrigeration
Induction ranges
IQ-Touch wall ovens
Perfect Steam laundry
Front-load washers and dryers

Pricing and warranty

What it costs. What we stand behind.

$75

Diagnostic visit. Waived when you book the repair with us.
Written

90 days on consumables, 1 year on major parts, 2 years on sealed-system rebuilds. Quoted in writing before work starts.
CSLB

#1136642. Bonded and insured. We file warranty paperwork when applicable.

Nearby cities

Electrolux service in neighboring cities.

FAQ

Electrolux in Alameda questions, answered.

How fast can you get to Alameda from San Ramon?

Drive time is 35 to 50 minutes via 580 and the Webster Tube. We pair Alameda with our Oakland route, so island calls land on routed days. Booked windows get a written arrival time before we leave the shop.
My Electrolux front-load washer leaks from the door. Is it the boot?

Usually, yes. The Perfect Steam boot tears low on the seal and weeps during the wash. We carry the OEM boot in both 27-inch sizes and replace it on the first visit. We check the drain pump and the outer-tub seal before condemning the boot, since a slow drain looks like a leak.
Why does my heat-pump dryer take forever to dry?

Almost always the condenser fins are packed with lint. Heat-pump models need those fins cleaned about every twelve months. We clean and test the cycle. If the heat pump itself is faulty we tell you straight, but nine times out of ten it is just the fins.

Need Electrolux service in Alameda?

Tell us what is broken. We will quote it.