You're based in San Ramon. Is San Bruno really a normal stop for you?

It's a genuine drive from San Ramon, so we handle it by keeping a technician who lives on the Peninsula, in San Mateo County, covering San Bruno along with South San Francisco and Millbrae directly. You get someone who's already on this side of the bay, not someone starting the trip when you call.

Does the wind coming off San Bruno Mountain actually affect appliances?

For anything sitting in a garage on the hillside side of town, yes. The temperature swings between a cold windy night and a warm afternoon are bigger there than on the flatter streets, and that cycling is hard on compressor start components over years of use.

My Kenmore's display shows a normal temperature but the food inside isn't staying cold. What's going on?

That's almost always a sensor reading wrong rather than the compressor failing outright. I bring an independent thermometer to every call for exactly this reason, since trusting the fridge's own display can send you chasing the wrong repair.

KENMORE · SAN BRUNO

Service · All Kenmore Models

Kenmore Refrigerator & Freezer Repair · San Bruno, CA

Kenmore refrigerator and freezer repair in San Bruno, where the wind gap off San Bruno Mountain hits the Rollingwood hillside kitchens hardest

$99 diagnostic (credited toward the repair)
Same or next-day best effort
CSLB #1136642

Call (925) 999-4095

Kenmore in San Bruno

Kenmore in San Bruno kitchens.

San Bruno Mountain creates a wind gap that funnels straight through neighborhoods like Rollingwood and Portola Highlands, and homes built into that hillside get more temperature swing in the garage than the flatter streets near Tanforan. That matters for any refrigerator kept out there, and San Bruno still has plenty of older Whirlpool-built Kenmores, 106 series, doing exactly that job.

Closer to the BART station and the Tanforan redevelopment, newer condos and townhomes are more likely to have a Kenmore Elite built by LG, 795 series, which fails in completely different ways than the older units up the hill.

ADRIUM Service Solutions is San Ramon based, and for San Bruno we send the technician we keep on the Peninsula, in San Mateo County, rather than routing someone across two bridges. Owner Andrew Kuznetsov, EPA 608 Universal certified, CSLB #1136642. Diagnostic is $99, credited toward the repair. Written quotes, 7 days a week.

San Bruno details

Kenmore service in San Bruno: the local facts.

San Bruno is about 26 miles from our base in San Ramon, in a straight line. We service ZIP code 94066 in San Bruno.

Across the Bay Area we completed more than 1,200 repair and service jobs in the last 12 months.

Our nearest published Kenmore case study is from San Ramon, about 26 miles away: Kenmore Elite Washer Not Draining in San Ramon: Drain Pump Replacement.

Kenmore product lines and all 65 cities we cover for the brand are on our Kenmore page.

Published jobs near San Bruno

Millbrae, CA · 3 mi away · French Door Refrigerator

GE French Door Refrigerator Freezer Icing Up and Ice Maker Over-Icing
Read case →

See all case studies →

Common repairs we handle.

Defrost heater and thermostat failing together. When a San Bruno freezer packs solid with frost while the fresh food side runs warm, the defrost heater or the defrost thermostat has usually quit, and on these older units the two tend to go around the same time. I test the heater element and the thermostat contacts separately so you're not paying to replace a part that was already fine.
Start capacitor weakening on hillside compressors. The wider temperature swing that Rollingwood and Portola Highlands get from the mountain wind gap puts extra strain on a compressor's start capacitor over the years. The symptom is a hum, a clunk, then silence, and I check the capacitor's actual microfarad reading against spec rather than assuming it's bad just because the compressor won't start.
Temperature sensor drift on Elite models near Tanforan. Newer LG-built Kenmore Elites around the Tanforan area sometimes read the display temperature fine while the actual compartment runs several degrees warm, which traces back to a drifting thermistor rather than the compressor. I verify with an independent thermometer in both compartments before I touch a sensor, since the display can lie.

Pricing and warranty

What it costs. What we stand behind.

$99

Diagnostic visit. Credited toward the repair.
Written

Parts and labor, 3 months to 2 years depending on the type of repair. Quoted in writing before work starts.
CSLB

#1136642. Bonded and insured. We file warranty paperwork when applicable.

Nearby cities

Kenmore service in neighboring cities.

All 65 Kenmore cities →

FAQ

Kenmore in San Bruno questions, answered.

You're based in San Ramon. Is San Bruno really a normal stop for you?

It's a genuine drive from San Ramon, so we handle it by keeping a technician who lives on the Peninsula, in San Mateo County, covering San Bruno along with South San Francisco and Millbrae directly. You get someone who's already on this side of the bay, not someone starting the trip when you call.
Does the wind coming off San Bruno Mountain actually affect appliances?

For anything sitting in a garage on the hillside side of town, yes. The temperature swings between a cold windy night and a warm afternoon are bigger there than on the flatter streets, and that cycling is hard on compressor start components over years of use.
My Kenmore's display shows a normal temperature but the food inside isn't staying cold. What's going on?

That's almost always a sensor reading wrong rather than the compressor failing outright. I bring an independent thermometer to every call for exactly this reason, since trusting the fridge's own display can send you chasing the wrong repair.

Need Kenmore service in San Bruno?

Tell us what is broken. We will quote it.