How does a San Ramon company handle HVAC calls in Millbrae?

On scheduled Peninsula days. The run over the San Mateo Bridge takes about 50 minutes, and we pair Millbrae with neighboring Hillsborough so the routing is efficient. For no-heat and no-cool calls we prioritize, and the fault-code diagnosis usually means one visit to identify and a fast follow-up if a distributor part is needed.

Are there rebates for replacing my old furnace with a Lennox heat pump?

Rebate programs change and stack differently depending on your utility and the equipment tier, so I will not quote you a number from memory. We confirm what is actually paying at estimate time and write the real figures into your quote.

Why did my last contractor say Lennox parts are a problem?

Because Lennox restricts many parts to its own distributor network, some shops cannot get them quickly and some will not try. We source through the proper channel and give you the true lead time up front. It is sometimes a day or two longer than universal-parts brands, and we plan the repair around that instead of pretending otherwise.

LENNOX · MILLBRAE

Service · All Lennox Models

Lennox Heat Pump, AC & Furnace Repair · Millbrae, CA

Lennox furnace, heat pump, and AC repair in Millbrae, with the parts caveat told up front.

$75 diagnostic (waived with repair)
Same or next-day best effort
CSLB #1136642

Call (925) 999-4095

Lennox in Millbrae

Lennox heating and cooling in Millbrae.

Lennox builds some of the highest-efficiency residential HVAC equipment on the market, and Millbrae's fog-belt-edge climate is exactly where a modulating furnace or a variable-capacity heat pump earns its keep. The mid-century housing stock here got a wave of system replacements over the last decade, and a good share of it went Lennox.

Here is the caveat I give every Lennox owner before we start: Lennox runs a closed parts channel. Many components are distributor-only, which can add a day or two to a repair compared to a Carrier or a Goodman. I would rather tell you that at the quote than surprise you mid-repair. The equipment itself is excellent, and once we identify the failed part the fix is straightforward.

ADRIUM is EPA Section 608 Universal certified and CSLB licensed, #1136642. Diagnostic is $75, waived with repair. Repairs carry 1-year warranty, and full system installs carry 10-year parts and 10-year labor.

Common repairs we do

What we close on the truck.

SLP or EL-series furnace short cycling on a pressure or flame fault. High-efficiency Lennox furnaces log fault codes, and we read them instead of guessing. Common culprits in Millbrae's damp air are a clogged condensate trap tripping the pressure switch and a dirty flame sensor dropping the flame signal. Both are quick fixes when diagnosed by code.
Variable-speed blower module failure. The ECM blower modules in Lennox air handlers fail more often than the motors themselves. Symptoms are no airflow with a healthy call for heat, or a blower that surges. We test the module and motor separately, because replacing the whole assembly when only the module died wastes several hundred dollars.
Heat pump stuck in defrost or icing outdoors. Millbrae's cool marine nights put Lennox heat pumps into frequent defrost cycles, and a failing defrost board or sensor leaves the outdoor coil iced solid. We verify sensor resistance, board operation, and refrigerant charge, since low charge mimics a defrost fault and gets misdiagnosed constantly.

Models we service

Lennox product lines.

Gas furnaces
Heat pumps and AC condensers
Air handlers and evaporator coils
Variable-capacity and communicating systems
Packaged units

Pricing and warranty

What it costs. What we stand behind.

$75

Diagnostic visit. Waived when you book the repair with us.
Written

90 days on consumables, 1 year on major parts, 2 years on sealed-system rebuilds. Quoted in writing before work starts.
CSLB

#1136642. Bonded and insured. We file warranty paperwork when applicable.

Nearby cities

Lennox service in neighboring cities.

More cities

Lennox across our service area.

FAQ

Lennox in Millbrae questions, answered.

How does a San Ramon company handle HVAC calls in Millbrae?

On scheduled Peninsula days. The run over the San Mateo Bridge takes about 50 minutes, and we pair Millbrae with neighboring Hillsborough so the routing is efficient. For no-heat and no-cool calls we prioritize, and the fault-code diagnosis usually means one visit to identify and a fast follow-up if a distributor part is needed.
Are there rebates for replacing my old furnace with a Lennox heat pump?

Rebate programs change and stack differently depending on your utility and the equipment tier, so I will not quote you a number from memory. We confirm what is actually paying at estimate time and write the real figures into your quote.
Why did my last contractor say Lennox parts are a problem?

Because Lennox restricts many parts to its own distributor network, some shops cannot get them quickly and some will not try. We source through the proper channel and give you the true lead time up front. It is sometimes a day or two longer than universal-parts brands, and we plan the repair around that instead of pretending otherwise.

Need Lennox service in Millbrae?

Tell us what is broken. We will quote it.